Pioneer VSX-47TX Manuel d'utilisateur télécharger pdf (Page 109)

109

Techno Tidbits & Problem-solving

EXPERT

During playback of a DVD

audio source, the player

shows a transfer rate of

96kHz, but the receiver does

not.

During playback of a DTS

96/24 source, the display

doesn't show 96kHz

During playback of a 96kHz

source, the display doesn't

show 96kHz

Remote control

Cannot be remote

controlled.

Other components can't be

operated with the system

remote.

The SR cable is connected,

but the connected

components can't be

operated with the remote.

Miscellaneous

HOME THX 7.1 channel

mode is selected, but there

are certain options that can't

be chosen.

There seems to be a time lag

between the speakers and

the output of the subwoofer.

• The multi channel connections are

analog, so there is no digital transfer.

• The receiver may be on a different mode

than STANDARD.

• One of the DIGITAL NR, MIDNIGHT,

LOUDNESS, and TONE features are

switched on.

• The setting for speakers other than the

surround back is set to NO.

• Re-EQ is set on.

• The receiver may be on a different mode

than STEREO.

• One of the DIGITAL NR, MIDNIGHT,

LOUDNESS, and TONE features are

switched on.

• Re-EQ is set on.

• The remote control batteries have worn

out.

• Too far away or bad angle of operation.

• There is an obstacle between the

receiver and the remote control.

• Strong light such as fluorescent light is

shining onto the unit's remote control signal

light-receiving window.

• A cord is connected to the CONTROL IN

terminal on this unit.

• The IR -Receiver type is mismatched

with the setting.

• The preset code settings are wrong.

• The battery wore out and the system

settings were cleared.

• The SR cable hasn't been connected

properly.

• The rest of the component connection

have not been made.

• The component you have hooked up is

not SR compatible.

• The current setting is for only one

surround back speaker.

• The subwoofer channel can be delayed

slightly if run through a low-pass filter.

• This is not a malfunction. See the

player's manual for more details.

• Switch to STANDARD mode (see p.43).

• Turn it/them off (see p.50-52).

• The source has been downmixed to 48

kHz.

• Set Re-EQ off (see p.98).

• Switch to STEREO mode (see p.43).

• Turn it/them off (see p.50-52).

• Set Re-EQ off (see p.98).

• Replace the batteries (see p.7).

• Operate within 7 m, 30° of the remote

sensor on the front panel (see p.8).

• Remove the obstacle or operate from

another position (see p.8).

• Avoid exposing the remote sensor on the

front panel to direct light.

• Connect cord to the correct jack.

• Disconnect the IR Receiver from the rear

panel, and set to the other IR Receiver type

using the remote control.

• Input the correct preset code.

• Reset the proper system settings.

• Reinsert the SR cable, making sure it is

the right jack (see p.78).

• Make sure an analog connection has

been made between the units.

• This is not a malfunction.

• Connect two surround back speakers and

make the settings accordingly (see p.25,

36-37).

• The MCACC system will automatically

compensate for a delay in the subwoofer

output during the Auto Surround Sound

Setup.

Symptom Cause Remedy

1 2 ... 104 105 106 107 108 109 110 111 112

Commentaires sur ces manuels

Pas de commentaire