Pioneer PRS-D2000SPL Manuel du propriétaire télécharger pdf (Page 17)

ENGLISH

ESPAÑOL

DEUTSCH

FRANÇAIS

ITALIANO

NEDERLANDS

êìëëäàâ

Example of installation on the floor

mat or on the chassis

1. Place the amplifier where it is to be

installed. Insert the supplied tap-

ping screws (4 mm × 18 mm) into

the screw holes. Push on the screws

with a screwdriver so they make

marks where the installation holes

are to be located.

2. Drill 2.5 mm diameter holes at the

point marked, and install the ampli-

fier, either on the carpet or directly

to the chassis.

Replacing the terminal cover

1. Align the unit and terminal cover,

and insert the screw.

2. Tighten the screw with a 4 mm

hexagonal wrench.

Changing the Direction of the Badge

1. To remove the badge, loose screws

by using a 2 mm hexagonal wrench.

2. Change the direction of badge, and

then tighten the screws with a

hexagonal wrench.

Drill a 2.5 mm

diameter hole

Floor mat or chassis

Screw

Terminal Cover

Screw

Badge

Tapping screw

(4 mm × 18 mm)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 127 128

Pas de commentaire

Pioneer PRS-D2000SPL Manuel du propriétaire Page 17