Pioneer HTP-074 Manuel d'utilisateur télécharger pdf (Page 25)

Listening to your system

Using the Sound Retriever

When audio data is removed during the compression

process, sound quality often suffers from an uneven sound

image. The Sound Retriever feature employs new DSP

technology that helps bring CD quality sound back to

compressed 2-channel audio by restoring sound pressure

and smoothing jagged artifacts left over after compression.

…

Press

S.RETRIEVER

to switch the S.RTV (Sound

Retriever) ON or OFF.

Note

• The Sound Retriever mode cannot be set to

, when the

DIRECT

mode or the

PURE DIRECT

mode is switched on.

Better sound using Phase Control

This receiver’s Phase Control feature uses phase correction

measures to make sure your sound source arrives at the

listening position in phase, preventing unwanted distortion

and/or coloring of the sound.

Phase Control technology provides coherent sound

reproduction through the use of phase matching for an

optimal sound image at your listening position. The default

setting is on and we recommend leaving Phase Control

switched on for all sound sources.

…

Press

PHASE

to switch the P.CTL (Phase Control) ON

or OFF.

Note

• Phase matching is a very important factor in achieving proper

sound reproduction. If two waveforms are ‘in phase’, they

crest and trough together, resulting in increased amplitude,

clarity and presence of the sound signal. If a crest of a wave

meets a trough, then the sound will be ‘out of phase’ and an

unreliable sound image will be produced.

•

If the speaker distance is not properly set, you may not

have a maximized Phase Control effect.

•

The Phase Control mode cannot be set to ON in the

following cases:

When the PURE DIRECT mode is switched on.

When the headphones are connected.

Setting the Audio options

There are a number of additional sound settings you can

make using the AV ADJUST menu. The defaults, if not

stated, are listed in bold.

Important

•

Note that if a setting doesn’t appear in the AV ADJUST

menu, it is unavailable due to the current source, settings

and status of the receiver.

Press

AV ADJUST

button.

Use





to select the setting you want to adjust.

Depending on the current status/mode of the receiver,

certain options may not be able to be selected. Check

the table below for notes on this.

Use





to set it as necessary.

See the table below for the options available for each

setting.

Press

RETURN

to confirm and exit the menu.

PHASEPHASEPHASEPHASE

S.RETRIEVERS.RETRIEVER

BT AUDIOBT AUDIO

BASSBASS

USBUSBTUNTUN

AUXAUX

BTBT

AVAV

ADJUSTADJUST

ADJUST

MUTEMUTE

HOMEHOME

MENUMENU

RETURNRETURNRETURNRETURN

VOLUME

Setting/What it does Option(s)

S.DLY (Sound Delay)

Some monitors have a slight delay when

showing video, so the soundtrack will be

slightly out of sync with the picture. By adding

a bit of delay, you can adjust the sound to

match the presentation of the video.

0 ms to 500 ms

(1 step : 5 ms)

Default: 0

MIDNIGHT/LOUDNESS

The MIDNIGHT allows you to hear effective

surround sound of movies at low volumes.

The

LOUDNESS

is used to get good bass and

treble from music sources at low volumes.

M/L OFF

MIDNIGHT

LOUDNESS

S.RTV (Sound Retriever)

Switches on/off the effect of Sound Retriever.

(see Using the Sound Retriever above)

OFF

DUAL MONO

Specifies how dual mono encoded Dolby

Digital soundtracks should be played.

CH1 – Channel 1

is heard only

CH2 – Channel 2

is heard only

CH1 CH2 – Both

channels heard

from front

speakers

F.PCM (Fixed PCM)

This is useful if you find there is a slight delay

before OFF recognizes the PCM signal on a

CD, for instance.

When

is selected, noise may be output during

playback of non-PCM sources. Please select

another input signal if this is a problem.

OFF

DRC (Dynamic Range Control)

Adjusts the level of dynamic range for movie

soundtracks optimized for Dolby Digital, DTS,

Dolby Digital Plus, Dolby TrueHD, DTS-HD

and DTS-HD Master Audio (you may need to

use this feature when listening to surround

sound at low volumes).

AUTO

MAX

MID

OFF

HTP-074_En.book 25 ページ２０１６年４月２５日　月曜日　午前１０時１２分

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Pioneer HTP-074 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Pioneer HTP-074