Pioneer VSX-D909S Manuel d'utilisateur télécharger pdf (Page 28)

Switching video system between PAL and NTSC (if necessary)

This receiver is able to use two types of video systems for its OSD (on screen display) either PAL or NTSC. If

you don't match the system on the amplifier with your home system no OSD will appear on your TV. The

default setting is NTSC, which is the standard in North America. If you use this system you don't need to

make any settings here. People with multi-system TVs don’t need to worry about changing the setting either.

If necessary, follow the instructions below to switch the type of video system.

1 Put the receiver in the STANDBY mode.

2 While holding down the LOUDNESS button

press the STANDBY/ON button.

The video system type will change depending on the state the

receiver was previously in. The new type, either PAL or NTSC,

will appear in the display. It will be shown for about seven

seconds and then the receiver returns to normal operating

mode.

To change the video system type again repeat steps 1 and 2.

Make sure you press the LOUDNESS button, using others

buttons may change this receiver’s settings.

SIGNAL

SELECT

DIGITAL

VOLUME

When a PAL system is selected

SIGNAL

SELECT

DIGITAL

VOLUME

When a NTSC system is selected

When using the PAL setting the OSD does not get displayed

in color.

On Screen Display

There are a number of possible ways to hook up the receiver to your video components, like a DVD player, and

hook up to your receiver to your TV, but some of them will not allow you to use the on-screen display of this

unit. To avoid this, you simply need to keep the following rules:

1 Always use the same type of video cords to hook up your video components to the receiver as you use to

hook up the receiver to your TV. For example, if you use composite video cords to hook up your DVD player

to the receiver, use composite video cords to hook up the receiver to your TV. If you use S video cords to

hook up your DVD player and the receiver, use S video cords to hook up the receiver to your TV.

2 Always make sure your TV is set to the appropriate input channel (for example, video 1). Your TV may have a

number of input channels and if you do not select the proper one, you will not be able to use this receiver’s

on-screen display, or, in fact see any picture from this receiver at all. If you are unsure how to choose an

input channel for your TV, refer to the manual which came with your TV.

You might, for example, use both composite and S video cords to hook up your video components with this

receiver and then use composite video cords to hook up this receiver to your TV. This arrangement would still

NOT let you see the on-screen displays from this receiver on your TV. The best idea is just to use one type of

video cords for all your video component and TV hook ups.

STANDBY/ON

DSP

MODE

SIGNAL SELECT ADVANCED STANDARD

STANDBY

AUDIO/VIDEO MULTI-CHANNEL RECEIVER

STEREO/

DIRECT

/DTS

Digital Signal

VSX-D909S

PHONES

S-VIDEO VIDEO

MULTI CH

INPUT

TONE

CHANNEL

SELECT

LOUDNESS

DIGITAL

SPEAKERS

TREBLE +

BASS +

L AUDIO R

VIDEO INPUT

STANDBY/ON

LOUDNESS

memo

Initial Set Up

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSX-D909S Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Pioneer VSX-D909S