Pioneer VSX-39TX Manuel d'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
28
Displays & Controls
1 Receiver SUB button
Press this button to select the sub receiver screen
(above) when the remote control is on the main
receiver screen.
2 TAPE 2 MONITOR button
Selects the tape deck (or MD recorder, etc.)
connected to the TAPE 2 MONITOR inputs/
outputs. Allows monitoring of a recording as it's
being made.
3 FL DIMMER button (See p.53)
Use to adjust the brightness of the main
display.
4 INPUT ATT button
Use to lower the input level of an analog signal
that is too powerful, thus causing the receiver to
distort (in tis case the overload indicator will be
flashing furiously).
5 SPEAKER A/B button
Use to select the speaker system. A is the
primary setting. It plays all speakers hooked up
to the A system. A & B setting only plays the
front speakers of both the A & B systems and
the subwoofer. Multi channel sources will be
down-mixed to these speakers so no sound will
be lost. B setting only plays the front speakers
connected to the B system and multi channel
sources will be down-mixed to these two
speakers. The button cycles through the
speaker systems as follows: A]B]A&B]off.
Receiver SUB Screen
SPEAKER
A/B
TONE
CH
SELECT
Receiver
MAIN SUB
TREBLE
SYSTEM
SETUP
CH
LEVEL
INPUT
ATT.
BASS
FL
DIMMER
TAPE 2
MONITOR
1
2
3
4
5
6
7
8
6 CH LEVEL button (See memo p.38)
Use this feature to adjust the level of individual
speakers during playback of a source.
7 SYSTEM SET UP button
Use to set up the speaker and sound systems. For
more information see “Setting for Surround
Sound“
starting on p.32.
8 TONE control buttons
TONE button
This button has two functions. Firstly, it
switches between TONE on and TONE BY-
PASS, which bypasses the tone circuitry.
Secondly, you need to press the button before
using the CHANNEL SELECT buttons to adjust
the BASS & TREBLE.
CH SELECT button
Switches the tone adjust controls between the
FRONT, CENTER, SURROUND and SUR-
ROUND BACK speakers. You can then use the
BASS and TREBLE controls to adjust the
sound.
BASS & TREBLE (+/–) buttons (See
p.51)
Use to adjust the high and low frequencies.
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Commentaires sur ces manuels

Pas de commentaire