Pioneer SC-1525-K Manuel d'utilisateur Page 92
- Page / 116
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Additional information
12
92
En
Positional relationship between speakers
and monitor
Position of front speakers and monitor
The front speakers should be as equidistant as possible
to the monitor.
Position of center speaker and monitor
Since mostly dialogs are output from the center speaker,
keeping the center speaker as close as possible to the
screen makes the overall sound more natural. For TVs
using Braun tubes, however, when installing the center
speaker on the floor, adjust its angle of elevation to point
it towards the listening position.
•If the center speaker is not of the shielded type, install
it away from the TV.
• When installing the center speaker on top of the
monitor, place it facing slightly downwards towards
the listening position.
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operat
ing conditions.
Power
TV
L
R
45° to 60°
Installation on floor
(Diagram as seen
from the side)
Monitor
Symptom Remedy
The power does not turn on. • Make sure that the power cord is plugged in to an active power outlet.
• Try disconnecting from the power outlet, then plugging back in.
Power cannot be turned off.
(ZONE 2 ON or ZONE 3 ON is
displayed.)
• Press the remote control’s ZONE 2 or ZONE 3, then press RECEIVER to switch the sub zone off.
The receiver suddenly switches
off or the iPod iPhone
indicator blinks.
• Check that there are no loose strands of speaker wire touching the rear panel or another set of
wires. If so, re-attach the speaker wires, making sure there are no stray strands.
• The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized
independent service company.
During loud playback the
power suddenly switches off.
• Turn down the volume.
• Lower the 63 Hz and 125 Hz equalizer levels in the Manual MCACC setup on page 77.
• Switch on the digital safety feature. While holding down ENTER on the front panel, press
STANDBY/ON to set this receiver to the standby mode. Use TUNE / to select D.SAFETY
OFF, and then use PRESET / to select 1 or 2 (select D.SAFETY OFF to deactivate this
feature). If the power switches off even with 2 switched on, turn down the volume. With 1 or 2 on,
some features may be unavailable.
The unit does not respond
when the buttons are pressed.
• Try switching the receiver off, then back on again.
• Try disconnecting the power cord, then connect again.
SC-1525_UXJCB.book 92 ページ ２０１０年４月２０日 火曜日 午後７時３２分
- Operating Instructions 1
- IMPORTANT 2
- VENTILATION CAUTION 3
- ESTABLISH A SAFE LEVEL: 4
- GUIDELINES: 4
- Contents 5
- 06 Listening to your system 6
- 07 Control with HDMI function 6
- 08 Using other functions 6
- 10 The Advanced MCACC menu 6
- 12 Additional information 7
- Before you start 9
- Controls and displays 11
- Front panel 14
- Connecting your equipment 16
- Placing the speakers 18
- Connecting the speakers 19
- Front height setup 22
- Front wide setup 22
- Speaker B setup 22
- Bi-Amping setup 22
- ZONE 2 setup 22
- About HDMI 23
- Connecting AM/FM antennas 31
- MULTI-ZONE setup 32
- LAN interface 33
- Bluetooth 34
- SETUP MIC 35
- Connecting an IR receiver 36
- Plugging in the receiver 37
- Basic Setup 38
- The Input Setup menu 40
- Basic playback 42
- Playing an iPod 43
- Playing a USB device 44
- Listening to the radio 46
- Listening to Satellite Radio 47
- Listening to XM Radio 47
- Listening to SIRIUS Radio 48
- Listening to your system 53
- Listening in stereo 55
- Using Stream Direct 55
- Selecting MCACC presets 56
- Choosing the input signal 56
- Control with HDMI function 57
- Before using synchronization 58
- About synchronized operations 58
- Setting the PQLS function 59
- Using other functions 60
- Setting the Video options 62
- Using the MULTI-ZONE controls 63
- RECEIVER 65
- Resetting the system 66
- Chapter 9: 67
- About the Remote Setup menu 67
- Operating multiple receivers 67
- Setting the backlight mode 70
- Using multi operations 71
- Using System off 71
- Controlling components 72
- The Advanced MCACC menu 75
- Manual MCACC setup 77
- Checking MCACC Data 81
- Data Management 82
- Speaker system setting 85
- Speaker Setting 85
- Channel Level 86
- Speaker Distance 86
- Network Setup menu 87
- IP address/Proxy setting 88
- Checking the MAC address 88
- Network Standby 88
- The Other Setup menu 89
- Flicker Reduction Setup 90
- EXTENSION Setup 90
- Multi Channel Input Setup 90
- Troubleshooting 92
- Additional information 100
- Surround sound formats 103
- About THX 103
- About iPod 104
- About SIRIUS and XM 105
- Preset code list 107
- Cleaning the unit 111
- Specifications 111
- In the USA/Aux Etats-Unis 116
- In Canada/Aux Canada 116
Produits connexes et manuels pour Récepteurs AV Pioneer SC-1525-K
(114 pages)
(144 pages)
(94 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.682 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels