Pioneer Video Card PDA-5002 Manuel d'utilisateur télécharger pdf (Page 9)

Installation and Connections

English

Installation and Connections

Connection to a personal

computer

Connection method differs depending on the computer

type. When connecting, please thoroughly read the

computer’s instruction manual.

Before making connections, be sure to make sure that

the personal computer’s power and display’s main power

is off.

For the PC input signals and screen sizes that the display

is compatible with, please refer to the plasma display’s

Operating Instructions.

Connection of separate SYNC analog RGB

source

Make separate SYNC connections for a personal

computer that has RGB output separated into 5 output

signals: green, blue, red, horizontal synchronization signal,

and vertical synchronization signal.

When connecting to INPUT2

GBRHDVD

(ON SYNC) (H/V SYNC)

75 2.2

Ω kΩ

INPUT2

When using INPUT2, set the impedance selector switch

to match the output impedance of the connected

computer’s synchronization signal.

When the output impedance of the computer’s

synchronization signal is above 75 Ω, set this switch to

the 2.2 kΩ position.

On-screen setup is necessary after connection.

Please see pages 14 and 15.

Connection of composite SYNC analog RGB

source

Make composite SYNC connections for a component

with output that has the vertical synchronization signal

layered on top of the horizontal synchronization signal.

When connecting to INPUT1

On-screen setup is necessary after connection.

Please see pages 14 and 15.

When connecting to INPUT2

When using INPUT2, set the impedance selector switch

to match the output impedance of the connected

component’s synchronization signal.

When the output impedance of the component’s

synchronization signal is above 75 Ω, set this switch to

the 2.2 kΩ position.

On-screen setup is necessary after connection.

Please see pages 14 and 15.

Notes

÷ When making composite SYNC connections, do not connect

anything to the VD jack. If connected to, the picture may not

be displayed properly.

÷ On some types of Macintosh

components, G ON SYNC and

composite SYNC are both output. With this type of

component, please connect using the G ON SYNC connection

(as shown left).

GBRHDVD

(ON SYNC) (H/V SYNC)

75 2.2

Ω kΩ

INPUT2

ANALOG RGB (ANALOG RGB)

INPUT1

OUTPUT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Pioneer Video Card PDA-5002 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Pioneer Video Card PDA-5002