Pioneer Video Card PDA-5002 Manuel d'utilisateur télécharger pdf (Page 16)

English

Operations

Selecting an Input Source

This section explains the basic operation of the plasma

display. Outlined on the following pages is how to turn

the main power on and off, put this display in the

operation or standby mode and how to select connected

components.

Before you begin, make sure you have:

•

Made connections between the plasma display and AV

components or personal computer as described in the

section “Installation and Connections” starting on page 6.

• Set up the on-screen menu to input signals from

components connected to INPUT1, INPUT2 and

INPUT5 as described in the section “Setting Up the

System” on page 14.

If no connections are made to these terminals,

on-screen setup is not necessary.

2,5

1 Switch MAIN POWER on the display to the on

position to turn the main power on.

The STANDBY/ON indicator lights red.

2 Press STANDBY/ON to put the plasma display in

the operation mode.

The STANDBY/ON indicator turns green.

Operations

3 Press INPUT on the remote control unit or the

display to select the input.

Input changes each time the display’s INPUT is

pressed as follows.

• When the menu screen is displayed, changing the

signal input will cause the menu screen to turn off.

• If the input computer signal is not supported by the

display, the following message will be displayed:

085

512 684

HzfV .

HzfH .

POUSUPNSREDTINALG

CAU I O NT

FULL

INPUT

020

––––

HzfV .

HzfH .

TOU NOARFGE

CAU I O NT

FULL

INPUT

4 Use VOLUME +/– on the remote control unit to

adjust the volume.

If no audio connections are made to the plasma

display, this step is not necessary.

5 When viewing is finished, press STANDBY/ON to

put the display in standby mode.

The STANDBY/ON indicator will blink and then remain

lit (red) indicating that the standby mode is engaged.

Operation is not possible while the STANDBY/ON

indicator is blinking (red).

6 Switch MAIN POWER on the display to the off

position to turn the main power off.

The STANDBY/ON indicator may continue to light for a

short while even after the main power is turned off.

This is a result of residual electric load impressed on

the circuitry, and the light will turn off presently.

CAUTION

Please do not leave the same picture displayed on the screen for

a long time. Doing so may cause a phenomenon known as

“screen burn” which leaves a ghost, or residual, image of the

picture on the screen.

Remote Control UnitDisplay Operating

Panel

2,5

3 INPUT1

INPUT5 2

3 INPUT2 3 INPUT3

INPUT4 2

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Pioneer Video Card PDA-5002 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Pioneer Video Card PDA-5002