Pioneer Super Tuner III D AVH-P4950DVD Manuel d'utilisateur télécharger pdf (Page 43)

% Touch D. WARN on the initial menu to

turn warning tone on.

# To turn warning tone off, touch D. WARN

again.

Switching the auxiliary setting

It is possible to use auxiliary equipment with

this unit. Activate the auxiliary setting when

using auxiliary equipment connected to this

unit.

% Touch AUX on the initial menu to turn

auxiliary setting on.

# To turn auxiliary setting off, touch AUX again.

Setting the illumination switch

You can choose whether to have the illumina-

tion of this unit switch on/off when the ignition

key is turned to the ACC position or the power-

off position.

% Touch ILM SW on the initial menu to

turn the illumination switch on.

Set the illumination switch ON to have the illu-

mination of this unit remain on when the igni-

tion key is turned to the ACC position. Set to

OFF to have the illumination off when the igni-

tion key is turned to the ACC position.

# To turn the illumination switch off, touch

ILM SW again.

Note

Never set the illumination switch on if the vehicle

does not have the ACC position. It may cause bat-

tery leakage.

Setting the rear output and

subwoofer controller

This unit’s rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (FULL) or subwoofer (SUB. W)

connection. If you switch the rear output set-

ting to SUB. W, you can connect a rear speak-

er lead directly to a subwoofer without using

an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (FULL). When rear output is

connected to full range speakers (when FULL

is selected), you can connect the RCA sub-

woofer output to a subwoofer. In this case, you

can select whether to use the subwoofer con-

troller’s (low pass filter, phase) built-in SUB.W

or the auxiliary FULL.

! When the multi-channel processor (e.g.,

DEQ-P7650) is connected to this unit, you

cannot operate this function.

1 Touch NEXT on the initial menu.

2 Touch REARSP.

3 Touch a or b to switch the rear output

setting.

Touch a to select full-range speaker and FULL

appears in the display. Touch b to select sub-

woofer and SUB. W appears in the display.

# When no subwoofer is connected to the rear

output, select FULL.

# When a subwoofer is connected to the rear

output, set for subwoofer SUB. W.

# When the rear output setting is SUB. W, you

cannot change the subwoofer controller.

4 Touch c or d to switch the subwoofer

output or non fading output.

Touch c to select subwoofer output and

SUB.W appears in the display. Touch d to se-

lect non fading output and FULL appears in

the display.

Operating this unit

En

43

Section

03

Operating this unit

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 84 85

Commentaires sur ces manuels

Pas de commentaire