Pioneer DEH-P3800MP Manuel d'utilisateur télécharger pdf (Page 33)

3 Press c or d to select the phase of sub-

woofer output.

Press c to select reverse phase and REV ap-

pears in the display. Press d to select normal

phase and NOR appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Press SW to select 80: 0.

Press SW until 80: 0 appears in the display.

# You can also select the subwoofer setting

menu by pressing AUDIO on the unit.

# When the subwoofer output is on, you can se-

lect 80: 0.

# If the subwoofer setting has been previously

adjusted, the frequency of that previously se-

lected will be displayed instead of 80.

2 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

506380100125 (Hz)

Only frequencies lower than those in the se-

lected range are outputted from the subwoo-

fer.

3 Press a or b to adjust the output level

of the subwoofer.

Each press of a or b increases or decreases

the level of the subwoofer. +6  24 is dis-

played as the level is increased or

decreased.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn on the

HPF (high pass filter). Only frequencies higher

than those in the selected range are outputted

from the front or rear speakers.

1 Press AUDIO to select HPF.

Press AUDIO until HPF appears in the display.

2 Press a to turn high pass filter on.

HPF : 80 appears in the display. High pass fil-

ter is now on.

# If the high pass filter has been previously ad-

justed, the frequency of that previously selected

will be displayed instead of HPF : 80.

# To turn high pass filter off, press b.

3 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

506380100125 (Hz)

Only frequencies higher than those in the se-

lected range are outputted from the front or

rear speakers.

Boosting the bass

Bass boost function boosts the bass level of

sound lower than 100 Hz. The more the bass

level is increased, the more the bass sound is

emphasized and the entire sound becomes

powerful. When using this function with the

subwoofer, the sound under the cut-off fre-

quency is boosted.

1 Press AUDIO to select BASS.

Press AUDIO until BASS appears in the dis-

play.

# You can also select the bass boost setting by

pressing and holding SW.

2 Press a or b to select a desired level.

0  6 is displayed as the level is increased or

decreased.

Audio Adjustments

En

33

English

Section

08

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 58 59

Commentaires sur ces manuels

Pas de commentaire