Pioneer PDK-TS14 Instructions d'exploitation télécharger pdf (Page 5)

English

12 to 15 mm

(1/2 to 5/8 inch)

Using a wall for stabilization

1 Attaching falling prevention bolts (hooks)

to the Plasma Display.

2 Using strong cords or chains to stabilize it

appropriately and firmly to a wall, pillar, or

other sturdy element.

Perform this work in the same way on the left and right

sides.

Note

Use hooks, ropes, chains, and

fittings that are available on the

market.

Recommended hook:

Nominal diameter M8

Length 12 to 15 mm (1/2 to 5/8 inch)

1 Hook

2 Cord or chain

Fitting

Stabilizing on table or floor

Stabilize the equipment as shown in the diagram using

screws that are available on the market.

Note

To stabilize the equipment on a

table or on the floor, use

screws that have a nominal

diameter of 6 mm (1/4 inch)

and that are at least 20 mm

(13/16 inch) long.

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.

 Position of table/floor screws

When stabilizing the stand to a table or the floor, use

nominal diameter 6 mm (1/4 inch) with a length above 20

mm (13/16 inch).

Unit: mm (inch)

Preventing Equipment from Falling Over

• A table or an area of the floor with adequate strength

should always be used to support the Plasma Display.

Failure to do so could result in personal injury and

physical damage.

• When installing the Plasma Display, please take the

necessary safety measures to prevent it from falling or

overturning in case of emergencies, such as

earthquakes, or of accidents.

• If you do not take these precautions, the Plasma

Display could fall down and cause injury.

• The screws, hooks, chains and other fittings that you

use to secure the Plasma Display to prevent it from

overturning will vary according to the composition and

thickness of the surface to which it will be attached.

• Select the appropriate screws, hooks, chains and other

fittings after first inspecting the surface carefully to

determine its thickness and composition and after

consulting a professional installer if necessary.

Min. 20 mm

(13/16 inch)

6 mm

(1/4 inch)

9 to 15 mm

(3/8 to 5/8 inch)

249 (9-13/16) 24 (1)

120

(4-23/32)

478

(18-13/16)

Side View

11 (13/32)

Caution

1 2 3 4 5 6 7 8 9 10 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDK-TS14 Instructions d'exploitation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Supports de sol en panneaux plats Pioneer PDK-TS14