Pioneer AVIC F500BT Manuel d'utilisateur télécharger pdf (Page 93)

Camera for “RearView”

[RearView] can be displayed the full-screen

rear camera image any time without relation

to the shift lever position after touching [Rear-

View] on the “AV Source” menu. [RearView]

is useful if you want to monitor an attached

trailer, etc.

CAUTION

Pioneer recommends the use of a camera which

outputs mirror reversed images, otherwise the

screen image may appear reversed.

p Immediately verify whether the display

changes to a rear view camera image when

the shift lever is moved to REVERSE (R)

from another position.

p When the whole screen changes to a rear

view camera image during normal driving,

switch to another setting.

p Initially, this function is set to “Off”.

1 Touch [Back Camera] on the “System

Settings” menu.

= For details, refer to Displaying the “System

Settings” menu on page 91.

The “Camera Input” screen appears.

2 Touch [On] next to “Camera” to acti-

vate the camera setting.

p Unless this setting is [On], you cannot

switch to “RearView”.

3 Touch [Battery] or [GND] next to

“Polarity” to select the appropriate polarity

setting.

! Battery — When the polarity of the con-

nected lead is positive while the shift lever

is in the REVERSE (R) position

! GND — When the polarity of the connected

lead is negative while the shift lever is in

the REVERSE (R) position

Adjusting the response

positions of the touch panels

(touch panel calibration)

If you feel that the touch panel keys on the

screen deviate from the actual positions that

respond to your touch, adjust the response po-

sitions of the touch panel screen.

p For adjustment, make sure to use a rela-

tively soft and tapered instrument so that

the screen is not scratched or damaged,

and gently touch the screen. If you press

the touch panel forcefully, the touch panel

may be damaged. Also, do not use a sharp

pointed metallic or hard tool such as a ball-

point pen or a mechanical pencil. Other-

wise the screen may become damaged.

1 Touch [Screen Calibration] on the “Sys-

tem Settings” menu.

A message confirming whether to start the ca-

libration appears.

p You can also start the calibration by keep

pressing MENU button on the “Top Menu”.

2 Touch [OK].

3 Touch and hold the arrows that point

to the center and corners of the LCD

screen.

The arrow indicates the order.

4 Touch anywhere on the screen.

The adjusted position data will be saved.

p Do not turn off the engine while saving the

adjusted position data.

Customizing preferences

En

93

Chapter

13

Customizing preferences

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 128 129

Commentaires sur ces manuels

Pas de commentaire