Pioneer PDP-5080HD Manuel d'utilisateur télécharger pdf (Page 26)

Preparation

Preparing the remote control unit

Inserting batteries

1 Open the battery cover.

2 Load the supplied two AA size batteries while inserting

their respective negative polarity (–) ends first.

• The battery polarities must correspond with the (+) and (–)

indicators in the battery compartment.

3 Close the battery cover.

Cautions regarding batteries

• The remote control unit cannot operate the system if the

batteries in the unit are weak. When this happens, replace the

batteries with new ones.

• When you replace the batteries, use alkaline batteries for the

remote control unit.

• Do not mix batteries of different types. Different types of

batteries have different characteristics.

• Do not mix old and new batteries. Mixing old and new batteries

can shorten the life of new batteries or cause chemical leakage

in old batteries.

• Do not leave dead batteries in the remote control unit;

chemical leakage will occur. If you find any chemical leakage,

wipe thoroughly with a cloth.

• The batteries supplied with this product may have a shorter life

expectancy due to storage conditions.

• If you will not use the remote control unit for an extended

period of time, remove the batteries from it.

Allowed operation range of the remote control

unit

Operate the remote control unit while pointing it toward the

remote control sensor located at the bottom right of the front

panel of the plasma display. The distance from the remote control

sensor must be within 7 m (23 feet) and the angle relative to the

sensor must be within 30 degrees in the right or left direction.

Note

• For the remote control sensor located on the PDP-4280HD, see

Part Names on page 13.

Cautions regarding the remote control unit

• Do not expose the remote control unit to shock, liquid, or high

humidity.

• Do not place the remote control unit under direct sunlight; the

unit may deform.

• The remote control unit may not work properly if the remote

sensor window of the plasma display is under direct sunlight or

strong lighting. In such case, change the angle of the lighting

or plasma display, or operate the remote control unit closer to

the remote sensor window.

• When any obstacle exists between the remote control unit and

the remote control sensor, the remote control unit may not

function.

• As the batteries become weak, the remote control unit can

function within a shorter distance from the remote control

sensor. Replace the batteries with new ones if necessary.

• The plasma display emits very weak infrared rays from its

screen. If you place such equipment operated through infrared

remote control as a VCR nearby, that equipment may not

receive commands from its remote control unit properly or

entirely. If this is the case, place that equipment at a location

far enough from the plasma display.

• Depending on the installation environment, infrared rays from

the plasma display may not allow this system to properly

receive commands from the remote control unit or may

shorten allowable distances between the remote control unit

and the remote control sensor. The strength of infrared rays

emitted from the screen differs, depending on images

displayed on the screen.

Battery disposal

When disposing of used batteries, please comply with

governmental regulations or environmental public

institution’s rules that apply in your country/area.

30º

7 m

Remote control

sensor

(23 feet)

PDP5080HD.book Page 26 Monday, April 9, 2007 7:49 PM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 284 285

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDP-5080HD Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Télévisions Pioneer PDP-5080HD