Pioneer VSX-515-S/-K Manuel d'utilisateur télécharger pdf (Page 80)

Additional information14

No sound is output or a noise

is output when software with

DTS is played back.

• Set the digital volume level of the player to full, or to the neutral

position.

• Make sure the player's settings are correct and/or the DTS signal out

is on. Refer to the instruction manual supplied with the DVD player.

• Set the input signal type to

DIGITAL

(see

Choosing the input signal

on page 40)

When a search is performed

by a DTS compatible CD

player during playback, noise

is output.

• This is not a malfunction, but be sure to turn the volume down to

prevent the output of loud noise from your speakers.

Everything seems to be set up

correctly, but the playback

sound is odd.

• Check that the positive/negative speaker terminals on the receiver

are matched with the corresponding terminals on the speakers (see

Connecting the speakers

on page 22).

There seems to be a time lag

between the speakers and the

output of the subwoofer.

• See

Automatically setting up for surround sound (MCACC)

on page 11

to set up your system again using MCACC (this will automatically

compensate for a delay in the subwoofer output).

After using the Auto MCACC

Setup, the speaker size

setting (

LARGE

SMALL

) is

incorrect.

• Low-frequency noise could have been caused by an air conditioner or

motor. Switch off all appliances in the room and rerun the Auto

MCACC Setup.

Can’t operate the remote

control.

• Replace the batteries (refer to page 5).

• Operate within 7 m, 30° of the remote sensor on the front panel (refer

to page 35).

• Remove the obstacle or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

•

VSX-815/915 only

– Unplug anything connected to the

CONTROL IN

jack and use remote normally (see

Operating other Pioneer components

on page 25).

The display is dark or off. • Press

FL DIMMER

on the remote control repeatedly to return to the

default.

VSX-815/915 only

– The SR

cable is connected, but the

connected components can’t

be operated with the remote.

• Reinsert the SR cable, making sure it’s connected to the right jack

(see

Operating other Pioneer components

on page 25).

• Make sure an analog connection has been made between the units.

• This feature only works with Pioneer products.

Problem

Remedy

VSX_815-915.book.fm 80 ページ２００５年３月１日　火曜日　午前１０時２２分

1 2 ... 75 76 77 78 79 80 81 82 83 84

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSX-515-S/-K Manuel d'utilisateur Page 80

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSX-515-S/-K