Pioneer PDP-501MX Manuel d'utilisateur télécharger pdf (Page 53)

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION 53

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION

4)Adjusting the angle

This mounting hardware can be tilted 25 degrees, without set increments. This work should be done by two people.

1Loosen screw c on the left and right vertical frames.

2While sliding the arm down, push the display to the desired angle.

3Once the desired angle is reached, tighten screw c on the left and right frames.

When mounting the display flush or parallel to the wall,

secure the movable and fixed portions of the mount frame

by tightening the screws a, as shown. This prevents

accidental tilting of the display. You must also tighten the

left and right c screws.

After mounting the unit at an angle, an additional

reinforcement measure can be taken by attaching an

appropriate wire flat bar using screws (a).

Measuring the opening distance x enables approximate

angle values to be determined.

X Angle

181mm 5˚

236mm 10˚

290mm 15˚

341mm 20˚

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 114 115

Pas de commentaire

Pioneer PDP-501MX Manuel d'utilisateur Page 53