Pioneer AVH-P8400BT Manuel d'utilisateur télécharger pdf (Page 65)

Setting the FM tuning step

Normally, the FM tuning step employed by

seek tuning is 50 kHz. When AF or TA is on,

the tuning step automatically changes to

100 kHz. It may be preferable to set the tuning

step to 50 kHz when AF is on.

! The tuning step remains at 50 kHz during

manual tuning.

1 Turn the unit off.

Refer to Basic operations on page 10.

2 Display the system menu.

Refer to Introduction of menu operations on

page 46.

3 Touch FM Step on the system menu to

select the FM tuning step.

Touching FM Step will switch the FM tuning

step between 50 kHz and 100 kHz. The se-

lected FM tuning step will appear.

RDS setting

Limiting stations to regional

programming

When AF is used, the regional function limits

the selection of stations to those broadcasting

regional programs.

1 Turn the unit off.

Refer to Basic operations on page 10.

2 Display the system menu.

Refer to Introduction of menu operations on

page 46.

3 Touch RDS Setup on the system menu.

4 Touch Regional on the menu to turn

the regional function on.

# To turn the regional function off, touch

Regional again.

Selecting alternative frequencies

When the tuner cannot get a good reception,

the unit automatically searches for a different

station in the same network.

1 Turn the unit off.

Refer to Basic operations on page 10.

2 Display the system menu.

Refer to Introduction of menu operations on

page 46.

3 Touch RDS Setup on the system menu.

4 Touch Alternative FREQ to turn AF on.

# To turn AF off, touch Alternative FREQ again.

Note

Sound may be temporarily interrupted by another

program during an AF frequency search.

Switching Auto PI Seek

The unit can automatically search for a differ-

ent station with the same programming, even

during preset recall.

1 Turn the unit off.

Refer to Basic operations on page 10.

2 Display the system menu.

Refer to Introduction of menu operations on

page 46.

3 Touch Auto PI on the system menu to

turn Auto PI Seek on.

# To turn Auto PI Seek off, touch Auto PI again.

Switching sound muting/

attenuation

Sound from this system is automatically

muted or attenuated when a signal from

equipment with a mute function is received.

! Sound from this system returns to normal

when the muting or attenuation is can-

celed.

1 Display the system menu.

Refer to Introduction of menu operations on

page 46.

2 Touch Mute/ATT until the desired set-

ting appears.

Touch Mute/ATT until the desired setting ap-

pears in the display.

En

65

Section

13

Menu operations

Menu operations

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 119 120

Commentaires sur ces manuels

Pas de commentaire