Pioneer AVH-P6300BT Manuel d'utilisateur télécharger pdf (Page 63)

Setting the video signal

When you connect this unit to an AV equip-

ment to this unit, select the suitable video sig-

nal setting.

! As this function is initially set to Auto, the

unit will automatically adjust the video sig-

nal setting.

However, the screen may turn black or

images may not be displayed properly

when Auto has been selected and the re-

ception is weak. Normally, select the appro-

priate TV signal.

! About your country TV signal, consult with

your nearest Pioneer dealer.

! You can operate this function only for the

video signal input into the AV input.

1 Display the system menu.

Refer to Introduction of menu operations on

page 40.

2 Touch Video Signal Setting on the func-

tion menu.

Video Signal Setting items are displayed.

! AV – Adjusts the AV video signal

! AUX – Adjusts the AUX video signal

! Camera – Adjusts the camera video signal

! TV – Adjusts the TV video signal

3 Touch c or d to select the desired

video signal appears.

Auto—PAL—NTSC—PAL-M—PAL-N—

SECAM

Selecting the area group

1 Select the TV source.

Refer to Basic operations of this unit on page

10.

2 Display the system menu.

Refer to Introduction of menu operations on

page 40.

3 Touch TV Country Group on the func-

tion menu.

4 Touch c or d until the desired area

group appears.

Country1 (CCIR channel)—Country2 (Italy

channel)—Country3 (U.K. channel)—

Country4 (OIRT channel)

Auto EQ (auto-equalizing)

The auto-equalizer automatically measures

the car’s interior acoustic characteristics, and

then creates an auto-equalizer curve based on

that information.

WARNING

As a loud tone (noise) may be emitted from the

speakers when measuring the car's interior

acoustic characteristics, never perform auto TA

or auto EQ while driving.

CAUTION

! Thoroughly check the conditions before per-

forming auto EQ as the speakers may be da-

maged if these functions are performed when:

— The speakers are incorrectly connected.

(For example, when a rear speaker is con-

nected as a subwoofer output.)

— A speaker is connected to a power amp de-

livering output higher than the speaker’s

maximum input power capability.

! If the microphone is placed in an unsuitable

position the measurement tone may become

loud and measurement may take a long time,

resulting in battery drainage. Be sure to place

the microphone in the specified location.

En

63

Section

12

Menu operations

Menu operations

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 103 104

Commentaires sur ces manuels

Pas de commentaire