Pioneer AVH-P6300BT Manuel d'utilisateur télécharger pdf (Page 51)

2 Touch Parametric EQ.

3 Touch a or b to select the desired item.

EQ (equalizer)—SP-Select (speakers)—Band

(bands)—Frequency (center frequency)—

Level (equalizer level)—Q. Factor (Q factor)

4 Touch d to select the equalizer.

Powerful—Natural—Vocal—Flat— Custom1

—Custom2—Super Bass

5 Touch b and then touch c or d to se-

lect the speaker to be adjusted.

Rear (rear speakers)—Center (center speaker)

—Front (front speakers)

# Speakers with the size set to Off cannot be se-

lected. (Refer to Setting the speaker setting on

page 47.)

6 Touch b and then touch c or d to se-

lect the equalizer band to be adjusted.

Low (low)—Mid (mid)—High (high)

7 Touch b and then touch c or d to se-

lect the center frequency of selected band.

40Hz—50Hz—63Hz—80Hz—100Hz—125Hz

—160Hz—200Hz—250Hz—315Hz—400Hz

—500Hz—630Hz—800Hz—1kHz—1.25kHz

—1.6kHz—2kHz—2.5kHz—3.15kHz—4kHz

—5kHz—6.3kHz—8kHz—10kHz—12.5kHz

8 Touch b and then touch c or d to ad-

just the equalizer level.

Range: +12 to –12

9 Touch b and then touch c or d to se-

lect the desired Q factor.

Narrow (narrow)—Wide (wide)

# Adjust the parameters of each band for the

other speakers in the same way.

Note

A center frequency can be selected for each

band and can be changed in 1/3-octave steps.

However, the interval between the selected center

frequencies cannot be shorter than 1 octave.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-

ated by auto TA and EQ (refer to Auto TA and

EQ (auto-time alignment and auto-equalizing)

on this page).

You can turn the auto-equalizer on or off.

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 40.

2 Touch Auto EQ.

# You cannot use this function if auto TA and

EQ have not been carried out.

3 Touch d to turn the auto-equalizer on.

# To turn the auto-equalizer off, touch c.

Auto TA and EQ (auto-time

alignment and auto-equalizing)

Auto-time alignment automatically adjusts the

time alignment according to the distance be-

tween the listening position and each speaker.

The auto-equalizer automatically measures

the car’s interior acoustic characteristics, and

then creates an auto-equalizer curve based on

that information.

WARNING

As a loud tone (noise) may be emitted from the

speakers when measuring the car’s interior

acoustic characteristics, never perform auto TA

or auto EQ while driving.

CAUTION

! Thoroughly check the conditions before per-

forming auto TA and EQ as the speakers may

be damaged if these functions are performed

when:

— The speakers are incorrectly connected.

(For example, when a rear speaker is con-

nected as a subwoofer output.)

— A speaker is connected to a power amp de-

livering output higher than the speaker’s

maximum input power capability.

En

51

Section

12

Menu operations

Menu operations

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Commentaires sur ces manuels

Pas de commentaire