Pioneer AVIC X3 Guide d'installation télécharger pdf (Page 26)

Installing the GPS aerial

CAUTION

Do not cut the GPS aerial lead to shorten it

or use an extension to make it longer. Alter-

ing the aerial cable could result in a short cir-

cuit or malfunction and permanent damage

to the navigation system.

Installation notes

! The aerial should be installed on a level sur-

face where radio waves will be blocked as

little as possible. Radio waves cannot be re-

ceived by the aerial if reception from the sa-

tellite is blocked. Installation on the vehicle

roof or boot lid is recommended to opti-

mise reception.

Roof

Rear shelf

Boot lid

! When installing the GPS aerial inside the

vehicle, be sure to use the metal sheet pro-

vided with your system. If this is not used,

the reception sensitivity will be poor.

! Do not cut the accessory metal sheet. This

would reduce the sensitivity of the GPS aer-

ial.

! Take care not to pull the aerial lead when

removing the GPS aerial. The magnet at-

tached to the aerial is very powerful, and

the lead may become detached.

! The GPS aerial is installed with a magnet.

When installing the GPS aerial, be careful

not to scratch the vehicle body.

! When installing the GPS aerial on the out-

side of the vehicle, always put it in the vehi-

cle when going through an automatic

vehicle wash. If it is left on the outside it

may be knocked off and scratch the vehicle

body.

! Do not paint the GPS aerial, as this may af-

fect its performance.

Parts supplied

GPS aerial Metal sheet

Clamp (5 pcs.) Waterproof pad

Installation

Engb

26

Section

04

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 181 182

Commentaires sur ces manuels

Pas de commentaire