Pioneer PDP-LX508G Manuel d'utilisateur télécharger pdf (Page 18)

Preparation

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the plasma

television and snap [2] into the back of [1] to lock the clamp.

• Speed clamps are designed to be difficult to undo once in

place. Please attach them carefully.

• Use pliers to twist the clamp 90º, pulling outward. The clamp

may deteriorate over time and become damaged if removed.

• Be careful not to subject any connecting cables to strain.

Note

• Use the speed clamps as necessary.

Tidying the speaker cables

Use the supplied bead bands as necessary to tidy the speaker cables.

Attaching the ferrite core

(when a ferrite core is not attached)

To help prevent noise, attach the supplied ferrite core to the

connector end of the power cord as shown. Use the supplied cable

tie to prevent the ferrite core from slipping on the cable.

Connecting the power cord

Note

• Disconnect the power cord from the power outlet when the

plasma television is not going to be used for a long period of time.

• After all other components are connected, connect the power

plug to the AC outlet.

MONITOR

OUT

SUB

WOOFER

Rear view

Speaker cable

Bead band

Ferrite core

Cable tie

To power outlet

AC power cord

As close as possible

MONITOR

OUT

SUB

WOOFER

Rear view

Power cord

To power outlet

Ferrite core

Partially eliminates noise

caused by the power source.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDP-LX508G Manuel d'utilisateur Page 18

Commentaires sur ces manuels