Pioneer PLASMA DISPLAY Manuel d'utilisateur télécharger pdf (Page 9)

English

Installation

OPTION1

RETURN

SEL. OK

RGB

AUTO

1080B

OFF

1024 768

EXIT

OSD

BNC INPUT

D-SUB INPUT

RGB SELECT

HD SELECT

INPUT SKIP

ALL RESET

Bottom side

Top side

Caution on when the plasma monitor is installed vertically

• Use the optional unit. Contact your store of purchase when installing.

• Rotate 90° clockwise as seen from the front when installing.

• After installing, check with the PIONEER logo mark

as seen from the front.

• Be sure to set “OSD ANGLE” to “V” when using.

* Failure to heed the above cautions may lead to malfunction.

How to use the remote control

Battery Installation and Replacement

Insert the 2 “AAA” batteries, making sure to set them in

with the proper polarity.

1.Press and open the cover.

2.Align the batteries according to the (+) and (–) indication

inside the case.

3.Replace the cover.

* The 1/8 Stereo Mini cable must be purchased separately.

Operating Range

* Use the remote control within a distance of about 7 m/

23ft. from the front of the monitor’s remote control sensor

and at horizontal and vertical angles of up to approximately

30°.

* The remote control operation may not function if the

monitor’s remote control sensor is exposed to direct

sunlight or strong artificial light, or if there is an obstacle

between the sensor and the remote control.

Handling the remote control

• Do not drop or mishandle the remote control.

• Do not get the remote control wet. If the remote control

gets wet, wipe it dry immediately.

• Avoid heat and humidity.

• When not using the remote control for a long period,

remove the batteries.

• Do not use new and old batteries together, or use different

types together.

• Do not take apart the batteries, heat them, or throw them

into a fire.

• When using the remote control in the wireless condition,

be sure to unplug the remote cable from the REMOTE

IN terminal on the monitor.

• When disposing of used batteries, please comply with

governmental regulations or environmental public

instruction’s rules that apply in your country/area.

Using the wired remote control mode

Connect the remote cable* to the remote control’s remote

jack and the “REMOTE IN” terminal on the monitor.

When the cable is connected, the mode automatically

switches to wired remote control. When the wired remote

control mode is used, the remote control can be operated

even if no batteries are loaded.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Pioneer PLASMA DISPLAY Manuel d'utilisateur Page 9

Commentaires sur ces manuels