Pioneer CD-625 Manuel d'utilisateur télécharger pdf (Page 7)

Precautions

Specifications

To assure proper operation of the unit, keep the vehicle interior

temperature within a normal range using the vehicle's air

conditioner of heater.

Keep the sound level low enough to let you hear the outside of

your car.

Enough care must be taken against battery overdischarge causd

by long operation of the set at a high sound level when the

engine is not running or is idling.

When replacing fuses, be sure to use only fuses of the rating

prescribed on the fuse holder.

In case of trouble

When the unit does not operate properly, contact your dealer

or the nearest authorized PIONEER Service Station.

Power source

.............................

DC 14.4 V (10.8 — 15.6 V allowable)

Grounding system

............................................................

Negative type

Dimensions..............................................120(W) x 25(H) x 150(D) mm

Weight...........................................................................................0.6 kg

Gain.........................................................................................................0 dB

Sub-woofer level control

............................................

-15 dB — -h15 dB

Frequency response

.........................................

10 — 30,000 Hz (±1 dB)

Distortion

...........................................................

0.05% (1 kHz, 500 mV)

Signal-to-noise ratio.........................................101 dB (lEC-A network)

Crossover frequency......................................................50 Hz — 200 Hz

Crossover slope

Low-Pass filter..............................................................-12 dB/octave

High-Pass filter.............................................................-12 dB/octave

Phase switch..................................................................................0/180°

Nominal input level

.....................................................................

500 mV

Max. input level..................................................................................2 V

Input impedance...................................................................................10 kil

Output impedance..................................................................................1 ki2

Max. output level

...............................................

...............................

2 V

Note:

Specifications and the design are subject to possible modification

without notice due to improvements.