Pioneer X1 Guide d'installation télécharger pdf (Page 25)

DIN Front/Rear-mount

This unit can be properly installed

either from “Front” (conventional DIN

Front-mount) or “Rear” (DIN Rear-

mount installation, using threaded

screw holes at the sides of unit chas-

sis). For details, refer to the following

illustrated installation methods.

Before installing the unit

• Remove the frame and the

holder.

To remove the frame, extend top and

bottom of the frame outwards in order

to unlock it.

Loosen the screws (2 × 3 mm) to

remove the holder. (When reattaching

the frame, point the side with a groove

downwards and attach it.)

• It becomes easy to remove the frame

if the front panel is released.

DIN Front-mount

Installation with the rubber bush

1. Decide the position of the side

brackets.

When installing in a shallow space,

change the position of side brackets. In

this case, stick conceal tape on parts

that protrude from the dashboard.

2. Install the unit into the dash-

board.

After inserting the holder into the

dashboard, select the appropriate tabs

according to the thickness of the dash-

board material and bend them.

(Install as firmly as possible using the

top and bottom tabs. To secure, bend

the tabs 90 degrees.)

• After installing the unit into the

dashboard, reattach the frame.

• If you prefer an off-set installation

in which the front panel is pushed

further back, when there is a space

available at the back of the unit, use

AD-GA10 (sold separately).

Rubber bush

Scre

w

Dashboard

Side bracket

Screw (2 × 3 mm)

182

53

Holder

Conceal tape

Side bracket

Flush surface screw (5 × 6 mm)

Holder

Frame

Screw (2 × 3 mm)

24

ENG/MASTER 96

English

Español

Deutsch

Français

Italiano

Nederlands

<CRD3958A/U> 25

CRD3958A_U_inst001_031_UK 11/12/04 13:09 Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 180 181

Commentaires sur ces manuels

Pas de commentaire