Pioneer PDP 427CMX Manuel d'utilisateur télécharger pdf (Page 106)

106

5 Attach the wall side hardware to the wall.

Install the wall side hardware (four locations) symmetri-

cally on the left and right side (one at each location

from the center of the

). Wall strength and ma-

terial determines the type of screws and bolts (sold

separately) needed for this installation.

Note

Check the strength of the wall and beams before in-

stalling the display.

Tilt Mount Unit: PDK-5011

4.6.3 Assembling the mounting hardware and mounting the Plasma Display

Special screws (M6)

2 Remove the hardware on the wall side half and the

hardware on the PDP side half.

3 Attach the PDP side hardware to the Plasma Display.

Note

• Place a sheet or protective cover to protect the

display from scratches or damage.

• Be sure to attach it on top of a flat table or similar

surface.

4 Fix the Plasma Display to the PDP side hardware with

M8 bolts (six locations).

Use the holes marked with the red triangle "%".

Wall side hardware

PDP side hardware

Top side of Plasma Display

1 Remove the special screws (two locations) from the

bottom of the wall mounting unit.

Top side of Plasma Display

Note

Be sure to install speakers at this stage.

For the installation method, refer to the speaker

instruction manual.

[507CMX : 427CMX]

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 287 288

Pas de commentaire

Pioneer PDP 427CMX Manuel d'utilisateur Page 106