Pioneer KURO PRO-141FD Manuel d'utilisateur télécharger pdf (Page 19)

Install Your Flat Panel Display

2.4 Connect the Power Cord to the Panel

The final connection is the power cord. Always connect the panel’s power cord to a three-pronged outlet, verifying

that the cord is properly grounded. The cord includes a noise filter. Using any other cord may fail to conform to

mandatory FCC standards.

As long as the flat panel display is plugged in to an outlet, some power is drawn through the panel. When the flat

panel display is not going to be used for a long period, unplug the panel from the power outlet. Unplugging the

panel extends the life of the plasma as well as saves energy.

Plug the cord in to the panel but do NOT plug it in to a power outlet yet.

2.5 Route then Bundle the Power Cord and Cables

Once the flat panel display is mounted, place additional equipment in the final position(s). Lay out the power cord,

panel cables, and any other device cables in a logical pattern that works for the location. Please consider the

following points when routing cables:

• Access to a 3-prong (grounded) power outlet

• Space for the noise filter between the panel and outlet

• Placement of cables under carpets or across walking paths

A reusable cable clamp is designed to lock the bundled cables in place. Your flat panel display has a total of three

holes (60 inches: two holes) to attach cable clamps to the back of the panel. Use the cable clamps as necessary.

Front

Rear

PRO-141FD

PRO-101FD

PRO-141FD_PRO-101FD.book Page 19 Monday, May 12, 2008 3:27 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 105 106

Pas de commentaire

Pioneer KURO PRO-141FD Manuel d'utilisateur Page 19