Pioneer VSX-LX60 Manuel d'utilisateur télécharger pdf (Page 23)

How to Interpret the Graphs (Continued)

Displaying reverb characteristics after calibration

To display the graph of your listening area’s reverb characteristics with the equalization performed by this

receiver (after calibration), you’ll need to select the “EQ ON” option from the “Reverb Measurement” menu.

Using this graph, you can conﬁrm the effects of MCACC calibration for your listening area.

1 Connect the receiver to your PC with a RS-232C cable.

See page 7 for more on connecting the RS-232C cable.

2 Select the “EQ Professional” option for “Manual MCACC”, and perform with

“Reverb Measurement” set to “EQ OFF”.

(See pa

ge 8 or page 44 of the receiver’s Operating Instructions.)

The reverb characteristics before equalization are measured.

If the “Auto MCACC” operation has never been performed, conduct the “Auto MCACC (ALL)” operation

here.

(See page 8 of the receiver’s Operating Instructions.)

3 Receive and save the data by selecting “Output PC” from “Data Management”.

When you receive and save this information on your PC, you will be able to see the graph of your

listening area’s reverb characteristics before calibration.

4 Select “Reverb Measurement” from the receiver’s “EQ Professional” menu and

choose the “EQ ON”.

(See pa

ge 8 or page 44 of the receiver’s Operating Instructions.)

Measure the room’s reverb characteristics after equalization with the microphone at the same position as

when the “Auto MCACC (ALL)” operation was performed. The measurements are performed with the EQ

values stored in the MCACC memory selected on the receiver, so before measuring the reverb

characteristics, select the MCACC memory to be measured after equalization.

Continue

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Pas de commentaire

Pioneer VSX-LX60 Manuel d'utilisateur Page 23