Pioneer VSX-516 Manuel d'utilisateur Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 80
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
Additional information
10
37
En
English
Français
Deutsch
Nederlands
Italiano
Español
Switching the speaker impedance
We recommend using speakers of 8
with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6
impedance rating.
With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
SP 6 OHM – Use this setting if your
speakers are rated at 6
.
SP 8 OHM – Use this setting if your
speakers are rated at 8
or more.
Power cord caution
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or an electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement
Specifications
Amplifier section
Continuous power output (stereo)
Front. . 100 W (20 to 20 000 Hz, THD 0.7 %, 8
)
1
Continuous power output (surround)
Front. . . . . 100 W per channel (1 kHz, 1.0 %, 8
)
Center . . . . . . . . . . . . . .100 W (1 kHz, 1.0 %, 8
)
Surround . . . . . . . . . . . . . . . . . 100 W per channel
(1 kHz, 1.0 %, 8
)
Surround Back . . . . . . . . . . . . 100 W per channel
(1 kHz, 1.0 %, 8
)
Audio section
Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT . . . . . . . . . . . . . . . 200 mV/47 k
Frequency response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT . . . . . . . . . . . . . . 5 Hz to 100 000 Hz dB
Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/
MD REC. . . . . . . . . . . . . . . . . . . . . .200 mV/2.2 k
Tone control
Bass. . . . . . . . . . . . . . . . . . . . . . . .± 6 dB (100 Hz)
Treble . . . . . . . . . . . . . . . . . . . . . . .± 6 dB (10 kHz)
Loudness. . . . . . +10 dB/+5 dB (100 Hz/10 kHz)
(at volume level –50 dB)
Signal-to-Noise Ratio (IHF, short circuited,
A network)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT . . . . . . . . . . . . . . . . . . . . . . 96 dB
Signal-to Noise Ratio [EIA, at 1 W (1 kHz)]
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT . . . . . . . . . . . . . . . . . . . . . . 79 dB
Note
1 Continuous average power output of 110 watts* per channel, min., at 8ohms, from 20 Hz to 20 000 Hz with no more than 0.7
%** total harmonic distortion (front).
* Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers.
** Measured by Audio Spectrum Analyzer.
11_additional_info.fm 37 ページ 2005年12月6日 火曜日 午後2時45分
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Commentaires sur ces manuels

Pas de commentaire