Pioneer SX-LX03 Manuel d'utilisateur Page 61
- Page / 132
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Additional information 11
61
En
English
FrançaisDeutsch
Nederlands
Italiano Español
No audio signal is
output from AUDIO
OUT jacks.
• Audio input from ANALOG RCA jacks cannot be output from AUDIO OUT
jacks.
No sound from
subwoofer.
• Check the speaker level settings (see Channel level setting on page 43).
• SX-LX08 model only:
– Check subwoofer for correct connections (see Connect the speakers on
page 24).
– Be sure subwoofer's power is turned ON.
– Raise subwoofer's volume level.
Can’t operate using the
remote control.
• Replace the batteries (see Putting the batteries in the remote control on page 9).
• Operate within 7 m, 30° of the remote sensor (see Using the remote control on
page 9).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Check that there’s nothing mistakenly plugged into the CONTROL IN jack.
• For operating the other Pioneer component connected to the CONTROL OUT
jack of this unit, make sure that the control cable and either an HDMI or analog
audio cable are connected (page 49).
• If an object is placed on top of the touch sensor, the sensor will be activated, thus
disabling the remote control unit operations. If the action indicator remains
continuously lighted, remove any object sitting on the touch sensor panel.
The front panel display
and indicators do not
appear.
• If the display mode is set to Auto Display, the display will automatically turn off
if no operation is performed for a period of one minute. Try performing an
operation.
Motion sensor not
working.
• The motion sensor is on the front of the unit. Make sure you are within 2.5 m and
40° of the sensor.
• Since the motion sensor uses infrared rays, it may not work correctly if placed in
direct sunlight or close to heat source.
• Minimum unit height must be 25 cm or above from ground level. The sensor will
not work properly when located at ground level.
• Motion sensor will not work if placed in a fully sealed cabinet (include glass /
clear cabinet).
Problem Remedy
LX03BD_1.book Page 61 Monday, July 28, 2008 2:12 PM
- IMPORTANT 2
- POWER-CORD CAUTION 3
- Contents 4
- Section One 5
- What’s in the box 6
- Controls and displays 7
- Controls and displays01 10
- Receiver 10
- Controls and displays 01 11
- Blu-ray disc player 14
- Speaker Setup Guide (LX03BD) 16
- Preparing the speakers 17
- FrançaisDeutsch 19
- Nederlands 19
- Italiano Español 19
- Connect the speakers 20
- Separately purchased 22
- Speaker Setup Guide (SX-LX08) 23
- Safety precautions when 24
- Home theater sound setup 24
- Connecting up 26
- Connecting up 03 27
- Connecting up03 28
- Getting started 29
- Getting started04 30
- Listening to your system 31
- Listening to your system05 32
- Using Advanced Surround 32
- Listening to your system 05 35
- Adjusting the bass and treble 35
- Boosting the bass level 35
- Adjusting sound delay 35
- Connecting an iPod 36
- Connecting an iPod 06 37
- Connecting an iPod06 38
- Listening to the radio 39
- Listening to the radio07 40
- Listening to the radio 07 41
- Using RDS 41
- Surround sound settings 42
- Surround sound settings 08 43
- Surround sound settings08 44
- Other connections 46
- Other connections 09 47
- Listening to the sound of an 47
- Other connections09 48
- Outputting the sound of this 48
- External AM antenna 49
- AM Loop antenna 49
- External 49
- FM antenna 49
- Connecting using HDMI 50
- HDMI Control 53
- HDMI Control10 54
- HDMI Control 10 55
- Setting the HDMI options 55
- Before using synchronization 55
- Synchronized amp mode 55
- Additional information 11 57
- Additional information11 58
- Surround sound formats 58
- Installation and maintenance 59
- Troubleshooting 60
- Resetting the system 64
- Specifications (LX03BD model) 65
- BDP-LX08 68
- Section Two 70
- Before you start 71
- Before you start01 72
- Before you start 01 73
- Player connections 76
- Player connections 02 77
- Player connections02 78
- Connecting the other audio 80
- Connecting the power cord 82
- Getting Started 83
- Getting Started03 84
- Getting Started 03 85
- Using the TOOLS menu 86
- Playback 90
- Using the Play Mode functions 95
- Playback04 100
- Playing from the Home Media 100
- Playback 04 101
- Adjusting audio and video 105
- Adjusting audio and video05 106
- Adjusting audio and video 05 107
- Adjusting the Audio DRC 107
- Advanced settings 108
- Advanced settings 06 109
- Advanced settings06 110
- Additional information 123
- Additional information07 124
- Additional information 07 125
- PIONEER CORPORATION 132
Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer SX-LX03
(76 pages)
(35 pages)
(12 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.575 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels