Pioneer NavGate HUD Guide de démarrage rapide télécharger pdf (Page 14)

Black plate (14,1)

Pass the fall prevention belt through as shown

in the illustration.

Pull the fall prevention belt downward and se-

cure it as it is pulled downward.

16 Lock the mounting bracket.

Push in the lock plates from the left and right

firmly to lock the mounting bracket.

17 Push the sun visor up to the horizontal

position.

18 Lock the main unit position.

Pull the HUD lock lever, and slide it to the lock

position.

1 Lock position

The main unit slides forward and the unit posi-

tion is locked.

19 Adjust the tilt of the main unit.

Adjust the angle to level the main unit.

Left LeftRight Right

Tilt the sun visor vertically about 20 degrees and

firmly tighten the two mounting screws at the

back of the main unit that were loosened in step

11.

! If the combiner protection sheet interferes

with the adjustment, remove the protection

sheet. Attach the combiner protection sheet

again after the adjustment is finished.

20 Adjust the direction of the main unit.

Open the diffuser and combiner of the main

unit.

1 Diffuser

2 Combiner

Adjust the direction of the main unit to align the

diffuser and combiner in the travelling direction.

1 Align the unit in the travelling direction

1 Adjust the combiner so that the diffuser

can be displayed in the centre of the

combiner.

! Be sure to adjust the main unit is to be

aligned in the travelling direction.

21 Unlock the main unit position.

Pull the HUD lock lever, and slide it to the lock-

release position.

Installing Main Unit

Section

Installing Main Unit

Engb

<CRD4765-A>14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 147 148

Commentaires sur ces manuels

Pas de commentaire

Pioneer NavGate HUD Guide de démarrage rapide Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Navigateurs Pioneer NavGate HUD