Pioneer S-LX70W Manuel d'utilisateur télécharger pdf (Page 8)

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with

this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other

components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks

listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

SPECIFICATIONS

Cabinet ....................... Floor type with CLOSED BOX system

(magnetically shielded)

Speaker........................................................... 30 cm cone type

Frequency response

.....................................25 Hz to 4000 Hz (set to BYPASS ON)

Power Amplifier Continuous Power Output (RMS)

................................................................... 300 W/4

Ω

(100 Hz)

Input (sensitivity at 100 Hz/impedance)

LINE LEVEL (RCA jack)................................... 160 mV/33 k

Ω

Output (Level at 100 Hz/impedance)

LINE LEVEL (RCA jack)...................................... 160 mV/1 k

Ω

Selectable CROSSOVER Frequencies

.......................................................50 Hz, 60 Hz, 70 Hz, 80 Hz,

100 Hz, 120 Hz, 160 Hz, 200 Hz

Outline Dimension

........................... 362 mm (W) x 365 mm (H) x 362 mm (D)

Weight (without package).............................................18.2 kg

Power Requirements................220 V to 230 V~, 50

Hz/60

Power Consumption......................................................... 90 W

Power Consumption in standby..................................... 1.0 W

Accessories............................................... RCA plug cord x 1

Power cable x 1

Polishing cloth x 1

Warranty card x 1

Operating instructions

Specifications and design subject to possible

modification without notice, due to improvements.

Published by Pioneer Corporation.

is a trademark placed on a product with

Pioneer’s Phase Control Technology.

The Technology enables high-grade 5.1ch with no delay

in the bass area.

SYMPTOM

CAUSE REMEDY

1 No power is being supplied

(Indicator does not light up

when power switch is turned

on.)

• Power supply plug is not

correctly inserted.

• Insert plug securely.

2 No sound

(Indicator is lit.)

• Connection of accessory RCA

plug cord is wrong or

disconnected.

•

VOLUME

knob is set to

MIN

• Check again and connect correctly.

• Turn clockwise slowly.

3 Sound is distorted.

• Level is too high.

• Input level is too high.

• Turn the

VOLUME

knob counter-

clockwise to lower the level.

• Turn the amplifier’s output level (volume,

bass control, bass boost) counter-

clockwise to lower the level.

4 Howling noise occurs.

• No power supplied to the

amplifier.

• Subwoofer level is set too high.

• Connect an amplifier and supply power.

• Place the subwoofer a good distance

from speakers. Turn the

VOLUME

knob

counter-clockwise to lower the volume.

5 Much noise when listening to

AM or FM broadcasts.

• The AM loop antenna or the FM

indoor antenna is close to this

unit.

• Increase the distance between the AM or

FM antenna (for indoor use) and this unit.

01_S_LX70W_En.book 8 ページ２００８年７月１８日　金曜日　午後５時４分

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Pioneer S-LX70W Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Pioneer S-LX70W