Pioneer PDP-5020FD Manuel d'utilisateur télécharger pdf (Page 16)

Install Your Flat Panel TV

2.2 Install the Panel Using a Stand

2.2.1 Use or Remove the Included Stand

The PDP-5020FD ships with the Pioneer table top stand (stand) attached. Attach the included stand to the panel

for the PDP-6020FD. For PDP-5020FD, attach the falling prevention metal fittings after placing the panel to stand

upright.

Attach the Stand to the Panel

1 ) Detach the speaker if it has already been added.

Refer to “Attach/Detach the Speaker” on page 18 for assistance.

2 ) Lay the flat panel TV down on a raised surface with the stand base hanging over the edge.

3 ) Place all stand parts on a soft cloth to avoid scratching.

If you are mounting the PDP-6020FD continue with Steps 4 and 5. If you are mounting the PDP-5020FD skip

to Step 7.

4 ) Turn the base cover over so that the bottom is facing up.

5 ) Insert the stand supports (legs) into the base cover.

Please carefully install the supports (left and right) so that they are in the correct positions. Misaligned supports

can damage the base and/or the supports.

6 ) Tighten the base screws to lock the supports in to place.

Note: Assemble the stand with a soft sheet placed under the base cover. If a sheet is not laid before assembly,

the front surface of the base cover may be scratched.

Installation screws

(M4 × 35 mm: black)

Falling prevention

metal fitting

(PDP-5020FD)

Do not handle the flat panel TV on a wagon or pallet that is

smaller than its stand. The stand will bend.

Screws

(4 x 10 mm: silver)

Completed

stand

Sheet

Screws

(4 x 10 mm: silver)

Front

Rear

Base cover

PDP6020FD.book Page 16 Monday, March 17, 2008 10:51 AM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 154 155

Pas de commentaire

Pioneer PDP-5020FD Manuel d'utilisateur Page 16