Pioneer X-CM42BTD-W Manuel d'utilisateur télécharger pdf (Page 38)

Additional information11

Handling discs

Storing

• Always place discs in their cases and store them

vertically, avoiding hot, humid places, places exposed to

direct sunlight and extremely cold places.

• Be sure to read the cautions included with the disc.

Cleaning discs

• Discs may not play if there are fingerprints or dust on

them. In this case, use a cleaning cloth, etc., to gently

wipe the disc from the inside towards the outside. Do not

use dirty cleaning cloths.

• Do not use benzene, thinner or other volatile chemicals.

Also do not use record spray or antistatic agents.

• For tough dirt, apply some water to a soft cloth, wring out

thoroughly, wipe off the dirt, then wipe off the moisture

with a dry cloth.

• Do not use damaged (cracked or warped) discs.

• Do not let the signal surface of discs get scratched or

dirty.

• Do not attach pieces of paper or stickers to discs. Doing

so could warp discs, making it impossible to play them.

Also note that rental discs often have labels attached to

them, and the label’s glue may have oozed out. Check

that there is no glue around the edges of such labels

before using rented discs.

About specially shaped discs

Specially shaped discs (heart-shaped, hexagonal, etc.)

cannot be played on this unit. Do not attempt to play such

discs, as they could damage this unit.

About iPod/iPhone/iPad

“Made for iPod” and “Made for iPhone” and “Made for iPad”

mean that an electronic accessory has been designed to

connect specifically to iPod, iPhone, or iPad, respectively, and

has been certified by the developer to meet Apple

performance standards. Apple is not responsible for the

operation of this device or its compliance with safety and

regulatory standards. Please note that the use of this

accessory with iPod, iPhone or iPad may affect wireless

performance.

iPad, iPhone, iPod, iPod nano and iPod touch are trademarks of

Apple Inc., registered in the U.S. and other countries.

Lightning is a trademark of Apple Inc.

Auto power off setting

Long press the  on the unit for 3 seconds to switch auto

power off setting ON/OFF.

• The operation can be conducted using only the



on the

unit.

• No need to set this using the remote control.

• Initial setting is set to

Note

• When the auto power off is set to

, “APD ON” will be

displayed on the main display.

• When the auto power off is set to

OFF

, “APD OFF” will be

displayed on the main display.

Restoring all the settings to the

defaults

Use the steps below to restore the all settings to their defaults.

1Press

 STANDBY/ON

to turn the power on.

2Press

on the remote control or

INPUT

repeatedly on the main unit to select CD input.

3Press

 OPEN/CLOSE

to open the disc tray.

4Press



STANDBY/ON on the unit for 3

seconds while pressing



• “DEFAULT” is displayed while the settings are being

restored. Power is turned off.

• No need to set this using the remote control.

X-CM32_VXE8_En.book 38 ページ２０１４年３月１２日　水曜日　午後２時５２分

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Pioneer X-CM42BTD-W Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer X-CM42BTD-W