Pioneer VSX-859RDS-G Manuel d'utilisateur télécharger pdf (Page 29)

SET

Switching video system between PAL and NTSC (if necessary)

This receiver is able to use two types of video systems for its OSD (on screen display) either PAL or NTSC. If

you don't match the system on the amplifier with your home system no OSD will appear on your TV. The

default setting is PAL. If you use this system you don't need to make any settings here. People with multi-

system TVs don’t need to worry about changing the setting either. If necessary, follow the instructions below to

switch the type of video system.

1 Put the receiver in the STANDBY

mode.

2 While holding down the LOUDNESS

button press the STANDBY/ON

button.

The video system type will change depending on the

state the receiver was previously in. The new type, either

PAL or NTSC, will appear in the display. It will be shown

for about seven seconds and then the receiver returns to

normal operating mode.

To change the video system type again repeat steps 1

and 2.

When a PAL system is selected

When a NTSC system is selected

STANDBY/ON

LOUDNESS

Initial Set up

On Screen Display (VSX-859RDS only)

There are a number of possible ways to hook up the receiver to your video components, like a DVD player,

and hook up to your receiver to your TV, but some of them will not allow you to use the on-screen display of

this unit. To avoid this, you simply need to keep the following rules:

1 Always use the same type of video cords to hook up your video components to the receiver as you use to

hook up the receiver to your TV. For example, if you use composite video cords to hook up your DVD

player to the receiver, use composite video cords to hook up the receiver to your TV. If you use S video

cords to hook up your DVD player and the receiver, use S video cords to hook up the receiver to your TV.

2 Always make sure your TV is set to the appropriate input channel (for example, video 1). Your TV may have

a number of input channels and if you do not select the proper one, you will not be able to use this

receiver’s on-screen display, or, in fact see any picture from this receiver at all. If you are unsure how to

choose an input channel for your TV, refer to the manual which came with your TV.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 115 116

Pas de commentaire

Pioneer VSX-859RDS-G Manuel d'utilisateur Page 29