Pioneer VSA-AX10Ai-S Manuel d'utilisateur télécharger pdf (Page 26)

Connecting your equipment

Plugging in the amplifier

Only plug in after you have connected all your

components to this amplifier, including the speakers.

Caution

• Handle the power cord by the plug part. Do not pull

out the plug by tugging the cord, and never touch the

power cord when your hands are wet, as this could

cause a short circuit or electric shock. Do not place

the unit, a piece of furniture, or other object on the

power cord or pinch the cord in any other way. Never

make a knot in the cord or tie it with other cables. The

power cords should be routed so that they are not

likely to be stepped on. A damaged power cord can

cause a fire or give you an electric shock. Check the

power cord once in a while. If you find it damaged,

contact the Pioneer Service Center specified on your

warranty card for a replacement.

• Do not use any power cord other than the one

supplied with this unit.

• Do not use the supplied power cord for any purpose

other than that described below.

• The amplifier should be disconnected by removing

the mains plug from the wall socket when not in

regular use, eg., when on vacation.

1 Plug the supplied power cord into the AC IN

socket on the back of the amplifier.

2 Plug the other end into a power outlet.

About the AC outlet

(Switched 100W max.)

Power supplied through this outlet is turned on and off by

the amplifier's  STANDBY/ON switch. Total electrical

power consumption of connected equipment should not

exceed 100 W (0.4 A).

Caution

• Do not connect a TV set, monitor, heater, or similar

appliance to this unit's AC outlet.

• Do not connect appliances with high power

consumption to the AC outlet in order to avoid

overheating and fire risk. This can also cause the

amplifier to malfunction.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 103 104

Pas de commentaire

Pioneer VSA-AX10Ai-S Manuel d'utilisateur Page 26