Pioneer PDP-5080XA Manuel d'utilisateur télécharger pdf (Page 15)

Preparation 05

English

Preventing the plasma television from

falling over

After installing the stand, be sure to take special care to ensure that

the plasma television will not fall over and is stabilized to both the

wall and rack.

Stabilizing on a table or rack

Stabilize the plasma television as shown in the diagram using the

supplied plastic bands and screws.

Note

• To stabilize the plasma television on a table or rack, also use

commercially available wood screws that have a nominal

diameter of 4 mm and that are at least 20 mm long.

Drill a hole in the middle at the rear of the tabletop panel before

using a wood screw. Perform this work the same way on the left and

right sides.

Using a wall for stabilization

1 Attach falling prevention bolts (hooks) to the plasma

television.

2 Use strong cords to stabilize it appropriately and firmly to a

wall, pillar, or other sturdy element.

Perform this work in the same way on the left and right sides.

Use hooks, cords and fittings that are available on the market.

Recommended hook: Nominal diameter 8 mm, length 12 mm to

18 mm

Caution

• A table or rack with adequate strength should always be used to

support the plasma television. Failure to do so could result in

personal injury and physical damage.

• When installing the plasma television, please take the

necessary safety measures to prevent it from falling or

overturning in case of emergencies, such as earthquakes, or of

accidents.

• If you do not take these precautions, the plasma television could

fall down and cause injury.

• The screws, hooks, cords and other fittings that you use to

secure the plasma television to prevent it from overturning will

vary according to the composition and thickness of the surface

to which it will be attached.

• Select the appropriate screws, hooks, cords, and other fittings

after first inspecting the surface carefully to determine its

thickness and composition and after consulting a professional

installer if necessary.

20 mm min.

4 mm

8 mm to 15 mm

Supplied screw

(4 mm x 8 mm)

Wood screw

(commercially available,

4 mm x 20 mm min.)

Wood screw

Supplied screw

Supplied screwSupplied screw

12 mm to 18 mm

1. Hook

2. Cord

Fitting

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 361 362

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDP-5080XA Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer PDP-5080XA