Pioneer PDK-TS25 Manuel d'utilisateur télécharger pdf (Page 19)

English

12 mm to 15 mm

(1/2 to 5/8 inch)

* : 50 inch display model

** : 42 inch display model

120

(4-23/32)

522 (20-9/16)*

460 (18-1/8)**

522 (20-9/16)*

460 (18-1/8)**

24 (31/32)

356

(14-1/16)

Preventing Equipment from Falling Over

Stabilizing on TV table or other loca-

tion

Stabilize the equipment as shown in the diagram using

screws that are available on the market.

Note

 A TV table with adequate strength, width and depth

should always be used to support the Plasma Display.

Failure to do so could result in falling over.

 To stabilize the Plasma Display on a TV table, use screws

that have a nominal diameter of 6 mm (1/4 inch).

Select the appropriate screws after consulting a profes-

sional installer if necessary.

After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.

 Position of table screws: Without speakers

Unit: mm (inch)

Using a wall for stabilization

1 Attaching falling prevention bolts to the

Plasma Display.

2 Using strong cords to stabilize it appropri-

ately and firmly to a wall, pillar, or other

sturdy element.

 Perform this work in the same way on the left and

right sides.

 The length of the cords used must be long enough to

allow the stand to rotate freely.

Note

Use falling prevention bolts,

ropes and fittings that

are available on the market.

Recommended bolts:

Nominal diameter M8

Length 12 mm to 15 mm (1/2 to 5/8 inch)

Min. 20 mm

(13/16 inch)

6 mm

(1/4 inch)

9 mm to 15 mm

(3/8 to 5/8 inch)

• A table with adequate strength should always be used

to support the Plasma Display. Failure to do so could

result in personal injury and physical damage.

• When installing the Plasma Display, please take the

necessary safety measures to prevent it from falling or

overturning in case of emergencies, such as

earthquakes, or of accidents.

• If you do not take these precautions, the Plasma

Display could fall down and cause injury.

• The screws, hooks and other fittings that you use to

secure the Plasma Display to prevent it from

overturning will vary according to the composition and

thickness of the surface to which it will be attached.

• Select the appropriate screws, hooks and other fittings

after first inspecting the surface carefully to determine

its thickness and composition and after consulting a

professional installer if necessary.

Caution

 Because of the plasma display’s weight, if it could fall down, this can result in injury.

 For safety, be sure to take special care to ensure that the Plasma Display will not fall over.

Fittings

1Falling prevention bolts

2Cords

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 88 89

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDK-TS25 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer PDK-TS25