Pioneer PDK-TS07 Manuel d'utilisateur télécharger pdf (Page 9)

English

Attaching the Plasma Display

The Plasma Display is heavy, has no depth, and is

unstable, so be sure to have at least two people assemble

and install it.

Note

 Insert the bolts in the holes vertically.

 Place a sheet or protective cover to protect the display

from scratches or damage.

 Assemble only with the Plasma Display lying flat on a

table or similar surface.

1 With the Plasma Display lying flat, insert and

secure the two Installation bolts 1 (M8 x 20

mm) in the holes "a" located in center of the

Plasma Display housing.

At this point, tighten these bolts 1 only until the

threads are no longer visible when viewed from the side

(you will be unable to attach the display if the bolts are

screwed in completely).

Caution

Note

When laying down the Plasma Display, be careful so as to

not scratch or damage it.

Table. Regarding the stand pipe bolt holes when the stand is

used as a desktop stand

2 As shown in table, hook the stand pipe holes

(either A or B) onto the bolt heads of the

installation bolts 1, then slide the stand

upwards to the Plasma Display until it engages

the installation bolts 1.

It slides no more than 19 mm because of the structure

of the stand.

3 Pass the installation bolts 2 (M8 x 40 mm)

through the stand pipe holes (either A’ or B’),

and then screw them into the main Plasma

Display with the accessory hexagonal wrench.

 The combinations of holes used are A – A’ and

B – B’.

 Move the stand so that the stand screw holes and

the nuts that connect the main display line up

correctly.

 Be sure to tighten the bolts securely.

4 Tighten the installation bolts 1 firmly with the

accessory hexagonal wrench.

Be sure to tighten the bolts securely.

Plasma Display

Installation

bolt

Plasma Display

housing

Stop screwing

down the bolt

when the threads

are no longer

visible.

Installation bolt

(M8 x 20 mm)

Sheet

Holes "a"

(holes in center

of Plasma

Display)

Installation bolts

(M8 x 40 mm)

(Step 3)

Slide the stand

(Step 2)

Table top stand

Plasma Display model Bolt holes used with stand orientation

50 inch display model

43 inch display model

42 inch display model

Note

C and C’ indicate bolt holes for optional components that

are sold separately.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDK-TS07 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer PDK-TS07