Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your
dealer to carry out repair work.
Symptom
Cause Remedy
Disc tray is not expelled when OPEN/
CLOSE is pressed.
• Power plug is disconnected from outlet.
• The STANDBY/ON switch is set to STANDBY.
• Connect plug to amplifier or wall outlet.
• Press the STANDBY/ON switch ON.
When playback is started, it stops
immediately. Pauses or stops during
playback.
• Disc is loaded upside down.
• Smudges etc., on the disc.
• Load the disc correctly with the label side UP.
• Clean the smudges from the disc and then
play it again.
No sound
• Output cables are connected incorrectly or
loosely.
e Incorrect operation of stereo amplifier.
• Pin plugs and/or amplifier terminals are dirty,
e Player is in pause mode.
• Connect properly.
• Check the settings of amplifier switches and
sound volume controls.
• Clean away dirt.
• Press ►/!! (or ►).
Sound is distorted, noise is output.
• Incorrect connections.
• Pin plugs and/or amplifier terminals are dirty,
• Interference is being picked up from a TV
set.
• Connect to amplifier's AUX or CD terminals.
Do not connect to PHONO terminals.
• Clean away dirt.
• Switch OFF TV set, or move player away from
TV set.
With certain discs, loud noise is
produced, or play stops.
• Disc has bad scratch or warp.
• Disc is extremely dirty.
• Replace the disc.
• Clean disc.
The picture of the TV screen is
fluctuated or FM broadcast has noise
interference.
• Interference is being picked up from the CD
player.
• Unplug the AC power cord, or move the player
away from TV or tuner.
Remote control will not function.
(PD-207 only)
• Dead batteries.
• Too far from player or wrong angle.
• Obstruction between player and remote
control unit.
(PD-107 only)
• Control cable is not connected.
• Replace batteries.
• The distance between the remote control unit
and player should be no more than about 7
meters . The operational angle against the front
panel is within 30° from the right or left end of
the player.
• Relocate remote control unit or remove
obstruction.
• Connect control cable properly (see page 4).
Abnormal functioning of this unit may be caused by static electricity or other external interference. To restore normal operation, unplug the AC
power cord and then plug it in again.
11
<XRB1002>
(8 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels