Pioneer HTP-710 Manuel d'utilisateur Page 87

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 272
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 86
Additional information 10
87
En
English Deutsch Italiano EspañolFrançais
Nederlands
Important information regarding the HDMI connection
There are cases where you may not be able to
route HDMI signals through this system (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
If you aren’t receiving HDMI signals properly
through this system (from your component),
please try the following configuration when
connecting up.
Configuration
1
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the system. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
iPod messages
Note
1 • If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
• Depending on the component, audio output may be limited to the number of channels available from the connected
display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
• If you want to switch the input source, you’ll have to switch functions on both the system and your display unit.
• Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the
display every time you switch input sources.
Symptom Cause Action
iPod/USB Error 1
(I/U ERR1)
There is a problem with the signal path
from the iPod to the system.
Switch off the system and reconnect the
iPod to the system. If this doesn’t seem to
work, try resetting your iPod.
iPod/USB Error 2
(I/U ERR2)
The software version being used with the
iPod needs to be updated.
Update the software being used with the
iPod (please use the latest iPod software
versions later than the iPod updater 2004-
10-20).
An iPod not supported by this system is
connected.
Connect the iPod supported by this
system.
iPod/USB Error 3
(I/U ERR3)
When there is no response from the
iPod.
Update the iPod software to the latest
version. If this doesn’t seem to work, try
resetting your iPod.
No Track When there are no tracks in the category
selected on the iPod.
Select a different category.
HTP-710_VYXCN_En.book 87 ページ 2010年8月23日 月曜日 午後6時47分
Vue de la page 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 271 272

Commentaires sur ces manuels

Pas de commentaire