Pioneer CP-ST100 Manuel d'utilisateur télécharger pdf (Page 3)

Assembling the speaker stands

Caution

• Pioneer is not responsible for any accidents or damage that

result from improper installation, misuse or modification of

the product, or natural disasters.

Assemble the speaker stands as illustrated below. Please note

that a medium-sized Phillips screwdriver is required for

assembly.

The accompanying illustration shows the fully assembled

speaker stand, without speakers or wires.

1 Fasten the wire clips to the arms.

Peel the protective paper backing from the clip and affix the

clip to the indentation on the underside of the arm as

shown.

2 Fasten angle brackets to speakers.

Peel the protective paper backing from the gasket and affix

the gasket to the angle bracket as shown.

• Affix the gasket to the square surface of the angle bracket. Be

sure to confirm the direction of the gasket so as to properly

align the gasket’s hole with the screw hole in the angle

bracket.

Fasten the angle bracket to the speaker. Orient the gasket

material with the rear surface of the speaker, and align the

screw hole in the angle bracket with the speaker’s screw

hole, then use the furnished screw (M5xL10) to securely

fasten the angle bracket to the speaker.

• In the event the speaker is furnished with two screw holes,

fasten the angle bracket to the upper of the two holes.

• The angle bracket has been originally designed to be

mounted with the rounded angle arm oriented upwards, but

in the event interference occurs with speaker terminals, the

rounded angle arm may also be mounted downward.

Speaker Installation Examples

3 Place a support (long) over the mounting post in the

stand base, and fasten securely with two countersunk

screws (M4xL6).

• The screw holes in the stand base are oriented to the rear

side.

• The support (long) is designed with specific up-down

orientation. Confirm the orientation before assembling.

4 Lay the stand on its side, and pass the speaker wires

into the hole in the stand base and through the

support.

Consult the owner’s manual for the speaker system and

confirm the proper wires to be used (wires may be color

coded).

Stand base

Cap

Arms

Support (long)

Supports (short)

Angle brackets

(In the event of interference

between speaker terminals

and angle bracket)

CP-ST100_EN.book 3 ページ２００８年７月１７日　木曜日　午前１０時８分

1 2 3 4 5 6 7 8 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Pioneer CP-ST100 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer CP-ST100