Pioneer PDK-TS27 Instructions d'exploitation Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 64
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
9
En
English
Checking the Standard Accessories
Check to make sure that you have all the standard accessories before assembly and installation.
Base cover × 1 Light-blocking shield × 1
(PDK-TS27A and PDK-TS29A only)
Screws 1
(4 mm × 10 mm: silver) × 4
Fall-prevention straps × 2
Operating instructions
(this document) × 1
Installation screws 2
(M8 × 60 mm: black) × 2
[for 42 inch display model]
Installation screws 4
(M8 × 23 mm: black) × 2
Stand pipe (L) × 1
Stand pipe (R) × 1
Installation screws 3
(M8 × 40 mm: black) × 2
[for 50 inch display model]
Screws 5
(M4 × 10 mm: black) × 2
Assembling the Stand
Assembly Procedure
1 Turn the base cover over so the underside
is facing up.
2 Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked "R" and stand
pipe (L) into the side marked "L".
Ensure that the open sides of the stand pipes face
inward. Insert the stand pipes, making sure to match
them to the raised portion of the base cover.
3 Tighten the screws 1 (4 mm × 10 mm:
silver) to stabilize the stand pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface
of the base cover may be scratched.
Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
Screws 1
(4 mm x 10 mm: silver)
Screws
1
(4 mm x 10 mm: silver)
Stand
pipe (R)
Base cover
Sheet
Stand pipe (L)
Ensure that the open
sides of the stand pipes
face inward. Insert the
stand pipes, making
sure to match them to
the raised portion of
the base cover.
Front
Rear
Completed
Table Top Stand
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Commentaires sur ces manuels

Pas de commentaire