Pioneer PRV-9000 Manuel d'utilisateur télécharger pdf (Page 27)

PRV-9000 Operating Instructions

The following messages may appear on-screen when using the DV IN/OUT

port on the recorder’s front panel:

 DV camcorder not connected

Check the cable connection from the camcorder to the jack. Reseat the

cable if necessary. Also verify that the camcorder is powered ON.

 The power is switched off

Check the power on the camcorder and turn on if necessary.

 Too many camcorders connected

The DV jack supports a single DV device at one time.

 No cassette

Load a cassette in to the connected equipment.

 Put into play or stop mode

The camcorder is either in camera/record mode or record-pause mode.

 Playback stopped

Verify that the tape is running and that the camcorder is sending a

signal.

 The DV camcorder does not operate

Check the camcorder for operation or power problems. Try switching

off the DVC link (detailed explanation in a later chapter).

If problems with audio or video occur, read through Chapter 10:

TROUBLESHOOTING for assistance.

Note: Some camcorders are incompatible with the remote control for the PRV-9000.

Operate the system manually if your camcorder is incompatible with the remote.

This recorder is equipped with copy-protection technology. Do not

use AV cables to connect this unit to a TV via a VCR or other device.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 149 150

Pas de commentaire

Pioneer PRV-9000 Manuel d'utilisateur Page 27