Pioneer DJM-850-K Manuel d'utilisateur télécharger pdf (Page 6)

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.

Refer to the operating instructions for the component to be connected.

Connect the power cord after all the connections between devices have been completed.

Be sure to use the included power cord.

Rear panel

OFF

RETURN

1 GND

2 HOT

3 COLD

CH 4CH 3

PHONO

CH 1

CD/LINE

PHONO CD/ LINE

LINE CD/LINE

SIGNAL GNDSIGNAL GND

TRS

MASTER1

BOOTH

REC OUTMASTER2

MIC2

MIDI OUT

CH1

CH2

CONTROL

DIGITAL

MASTER OUT

CH 2

(MONO)

SEND

POWER

AC IN

CH3

CH4

1 34646434 55 7 82

de b 9h acg f

1 POWER button (page 14)

Turns this unit’s power on and off.

2 RETURN terminals (page 7)

Connect to the output terminal of an external effector. When the [L

(MONO)] channel only is connected, the [L (MONO)] channel input

is simultaneously input to the [R] channel.

3 PHONO terminals (page 7)

Connect to a phono level (MM cartridge) output device. Do not input

line level signals.

To connect a device to the [PHONO] terminals, remove the short-

circuit pin plug inserted in the terminals.

Insert this short-circuit pin plug into the [PHONO] terminals when

nothing is connected to them to cut external noise.

4 CD/LINE terminals (page 7)

Connect to a DJ player or a line level output component.

5 SIGNAL GND terminal (page 7)

Connects an analog player’s ground wire here. This helps reduce

noise when the analog player is connected.

6 LINE terminals (page 7)

Connect to a cassette deck or a line level output component.

7 MIC2 terminal (page 7)

Connects a microphone here.

8 MIDI OUT terminal (page 7)

Connects this to the MIDI IN terminal on an external MIDI

sequencer.

9 Kensington security slot

a CONTROL terminal (page 7)

This is a Ø 3.5 mm mini phone jack type DJ player control terminal.

If you connect a Pioneer DJ player using a control cable (supplied

with a DJ player), you can start playback of control other operations

of the DJ player with the fader of this unit.

b DIGITAL MASTER OUT terminal (page 7)

Outputs the master channel audio signals.

c BOOTH terminals (page 7)

Output terminals for a booth monitor, compatible with balanced or

unbalanced output for a TRS connector.

d REC OUT terminals (page 7)

These are output terminals for recording.

e MASTER2 terminals (page 7)

Connect to a power amplifier, etc.

f MASTER1 terminals (page 7)

Connect to a power amplifier, etc.

g SEND terminals (page 7)

Connect to the input terminal of an external effector. When the [L

(MONO)] channel only is connected, a monaural audio signal is

output.

h AC IN

Connects to a power outlet using the included power cord. Wait until

all connections between the equipment are completed before con-

necting the power cord.

Be sure to use the included power cord.

WARNING

The short-circuit pin plugs out of the reach of children and infants. If

accidentally swallowed, contact a doctor immediately.

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Pioneer DJM-850-K Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de DJ Pioneer DJM-850-K