Pioneer Premier DEH-P660 Manuel d'utilisateur télécharger pdf (Page 30)

Adjusting loudness

Loudness compensates for deficiencies in the

low- and high-sound ranges at low volume.

1 Press AUDIO to select Loud.

Press AUDIO until Loud appears in the dis-

play.

2 Press a to turn loudness on.

Loudness level (e.g., Loud MID) appears in

the display.

3 Press c or d to select a desired level.

Each press of c or d selects level in the fol-

lowing order:

LOW (low)MID (mid)HIGH (high)

4 Press b to turn loudness off.

Loud OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output

which can be turned on or off.

1 Press AUDIO to select Sub-W1.

Press AUDIO until Sub-W1 appears in the dis-

play.

# When the subwoofer controller setting is

PREOUT:FULL, you cannot select Sub-W1.

2 Press a to turn subwoofer output on.

Sub-W1 Normal appears in the display. Sub-

woofer output is now on.

# To turn subwoofer output off, press b.

3 Press c or d to select the phase of sub-

woofer output.

Press c to select reverse phase and Rev. ap-

pears in the display. Press d to select normal

phase and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Press AUDIO to select Sub-W2.

Press AUDIO until Sub-W2 appears in the dis-

play.

# When the subwoofer output is on, you can se-

lect Sub-W2.

2 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

5080125 (Hz)

Only frequencies lower than those in the se-

lected range are output from the subwoofer.

3 Press a or b to adjust the output level

of the subwoofer.

Each press of a or b increases or decreases

the level of the subwoofer. +6  6 is displayed

as the level is increased or decreased.

Using nonfading output

When the non fading output setting is on, the

audio signal does not pass through this units

low pass filter (for the subwoofer), but is out-

put through the RCA output.

1 Press AUDIO to select nonfading output

on/off setting.

Press AUDIO until NonFad ON appears in the

display.

# When the subwoofer controller setting is only

PREOUT:FULL, you can switch to the nonfading

output on/off setting. (Refer to page 33.)

2 Press a to turn nonfading output on.

NonFad ON appears in the display. Nonfading

output is now on.

# To turn nonfading output off, press b.

Audio Adjustments

En

30

Section

07

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Commentaires sur ces manuels

Pas de commentaire