Pioneer DEH-P7750MP Manuel d'utilisateur télécharger pdf (Page 45)

3 Push Multi-Control up or down to ad-

just the level.

Each pushing Multi-Control up or down in-

creases or decreases the selected bass or tre-

ble level. +6  6 is displayed as the level is

increased or decreased.

4 Turn Multi-Control clockwise to select

Bass (bass and treble frequency adjust-

ment).

Bass appears in the display.

# If the treble frequency has been previously ad-

justed, Treble will be displayed.

5 Push Multi-Control left or right to select

the desired frequency.

Each pushing Multi-Control left or right se-

lects frequencies in the following order:

Bass: 4063100160 (Hz)

Treble: 2.5k4k6.3k10k (Hz)

Adjusting loudness

Loudness compensates for deficiencies in the

low- and high-sound ranges at low volume.

1 Use Multi-Control to select LOUD.

LOUD appears in the display.

2 Press Multi-Control to turn loudness

on.

Loudness level (e.g., Mid) appears in the dis-

play.

3 Push Multi-Control left or right to select

a desired level.

Each pushing Multi-Control left or right se-

lects level in the following order:

Low (low)Mid (mid)High (high)

4 To turn loudness off, press

Multi-Control again.

OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output

which can be turned on or off.

1 Use Multi-Control to select Sub-W1.

Sub-W1 appears in the display.

# You can also select the subwoofer setting

menu by pressing SW on the unit.

# When the subwoofer controller setting is

Preout :FULL, you cannot select Sub-W1.

2 Press Multi-Control to turn subwoofer

output on.

Normal appears in the display. Subwoofer out-

put is now on.

# To turn subwoofer output off, press

Multi-Control again.

3 Push Multi-Control left or right to select

the phase of subwoofer output.

Push Multi-Control left to select reverse

phase and Rev. appears in the display. Push

Multi-Control right to select normal phase

and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Use Multi-Control to select Sub-W2.

Sub-W2 appears in the display.

# You can also select the subwoofer setting

menu by pressing SW on the unit.

# When the subwoofer output is on, you can se-

lect Sub-W2.

2 Push Multi-Control left or right to select

cut-off frequency.

Each pushing Multi-Control left or right se-

lects cut-off frequencies in the following order:

50Hz80Hz125Hz

Audio Adjustments

En

45

English

Section

10

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 196 197

Commentaires sur ces manuels

Pas de commentaire