Pioneer Super Tuner III D DEH-P8950BT Manuel d'utilisateur télécharger pdf (Page 43)

Black plate (43,1)

# You can also select the function by pressing

FUNCTION on the remote control.

# To cancel initial settings, press BAND.

# You cannot select BT AUDIO when the Blue-

tooth audio player has been connected.

Selecting the display language

For your convenience, this unit equips multi-

ple language display. You can select the lan-

guage best suited to your first language.

1 Use MULTI-CONTROL to select

Language select.

2 Press MULTI-CONTROL to select the lan-

guage.

Each press of MULTI-CONTROL selects lan-

guages in the following order:

English—Español—Português

Setting the date

The calender display adjusted in this mode ap-

pears when the telephone source is selected

or sources and the feature demo are off.

1 Use MULTI-CONTROL to select

Calendar.

2 Push MULTI-CONTROL left or right to

select the segment of the calendar display

you wish to set.

Pushing MULTI-CONTROL left or right will se-

lect one segment of the calendar display:

Day—Month—Year

As you select segments of the calendar dis-

play the segment selected will blink.

3 Push MULTI-CONTROL up or down to

set the date.

Setting the clock

Use these instructions to set the clock.

1 Use MULTI-CONTROL to select Clock.

2 Push MULTI-CONTROL left or right to

select the segment of the clock display you

wish to set.

Pushing MULTI-CONTROL left or right will se-

lect one segment of the clock display:

Hour—Minute

As you select segments of the clock display

the segment selected will blink.

3 Push MULTI-CONTROL up or down to

put a clock right.

Note

You can match the clock to a time signal by

pressing MULTI-CONTROL.

! If the minute is 00 to 29, the minutes are

rounded down. (e.g., 10:18 becomes 10:00.)

! If the minute is 30 to 59, the minutes are

rounded up. (e.g., 10:36 becomes 11:00.)

Setting the FM tuning step

The FM tuning step employed by seek tuning

can be switched between 100 kHz, the preset

step, and 50 kHz.

! If seek tuning is performed in 50 kHz steps,

stations may be tuned in imprecisely. Tune

in the stations with manual tuning or use

seek tuning again.

1 Use MULTI-CONTROL to select FM step.

2 Press MULTI-CONTROL to select the FM

tuning step.

Pressing MULTI-CONTROL repeatedly will

switch the FM tuning step between 50 kHz

and 100 kHz. The selected FM tuning step will

appear in the display.

Setting the AM tuning step

The AM tuning step can be switched between

9 kHz, the preset step, and 10 kHz. When

using the tuner in North, Central or South

America, reset the tuning step from 9 kHz (531

kHz to 1 602 kHz allowable) to 10 kHz (530 kHz

to 1 640 kHz allowable).

<CRD4206-A/N>43

Operating this unit

En

43

English

Section

02

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 203 204

Commentaires sur ces manuels

Pas de commentaire