Pioneer DEH-P3100UB Manuel d'utilisateur télécharger pdf (Page 26)

Adjusting initial settings

1 Press SRC and hold until the unit turns

off.

2 Press MULTI-CONTROL and hold until

CLOCK SET appears in the display.

3 Turn MULTI-CONTROL to select one of

the initial settings.

CLOCK SET (clock)—AUX1 (auxiliary input 1)

—AUX2 (auxiliary input 2)—SW CONTROL

(rear output and subwoofer controller)—

EVER SCROLL (ever scroll)—BT AUDIO (Blue-

tooth audio)—PIN CODE INPUT (pin code

input)—BT VER INFO (Bluetooth version infor-

mation)

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

# To cancel initial settings, press BAND/ESC.

# BT AUDIO, PIN CODE INPUT and

BT VER INFO can be selected only when Blue-

tooth adapter (e.g., CD-BTB200) is connected to

this unit.

Setting the clock

Use these instructions to set the clock.

1 Use MULTI-CONTROL to select

CLOCK SET in the initial setting menu.

Refer to Adjusting initial settings on this page.

2 Press MULTI-CONTROL to display the

setting mode.

# Press DISP/BACK/SCRL to return to the pre-

vious display.

3 Press MULTI-CONTROL to select the seg-

ment of the clock display you wish to set.

Each time you press MULTI-CONTROL, one

segment of the clock display is selected.

Hour—Minute

As you select segments of the clock display,

the selected segment blinks.

4 Turn MULTI-CONTROL to put a clock

right.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be

activated individually. Set each AUX source to

ON when using. For more information about

connecting or using auxiliary devices, refer to

Using the AUX source on page 29.

1 Use MULTI-CONTROL to select AUX1/

AUX2 in the initial setting menu.

Refer to Adjusting initial settings on this page.

2 Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL

again.

Setting the rear output and

subwoofer controller

This unit’s rear output (rear speaker lead out-

put and RCA rear output) can be used for full-

range speaker (REAR SP :FULL/

PREOUT:REAR) or subwoofer

(REAR SP :SUB W/PREOUT:SUB W) connec-

tion. If you switch the rear output setting to

REAR SP :SUB W, you can connect a rear

speaker lead directly to a subwoofer without

using an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (REAR SP :FULL). When rear

output is connected to full range speakers

(when REAR SP :FULL is selected), you can

connect the RCA subwoofer output to a sub-

woofer. In this case, you can select whether to

use the subwoofer controller’s (low pass filter,

phase) built-in PREOUT:SUB W or the auxili-

ary PREOUT:REAR.

Initial Settings

En

26

Section

04

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 176 177

Commentaires sur ces manuels

Pas de commentaire