Pioneer DVH-P590MP Manuel d'utilisateur télécharger pdf (Page 55)

Using the AUX source

This unit can control an auxiliary equipment

such as VCR or portable device (sold sepa-

rately). When connected, auxiliary equipment

is automatically recognized as AUX source

and assigned to AUX.

About AUX connection method

You have two methods to connect auxiliary

equipments to this unit.

Mini pin plug cable (AUX1)

When connecting auxiliary equipment using a

mini plug cable

iPod and portable audio/video player can be

connected to this unit via mini plug cable.

! If an iPod with video capabilities is con-

nected to this unit via 3.5 mm plug (4 pole)

cable (e.g., CD-V150M), you can enjoy the

video contents of the iPod.

! It is possible to connect a portable audio/

video player by using a 3.5 mm plug (4

pole) to RCA cable, which is sold sepa-

rately. However, depending on the cable, re-

verse connection between Red (right side

audio) cable and yellow (video) cable is re-

quired. Otherwise, audio and video may not

be correctly reproduced.

% Insert the mini plug into the micro-

phone/auxiliary input jack on this unit.

IP-BUS-RCA interconnector (AUX2)

When connecting auxiliary equipment using an

IP-BUS-RCA Interconnector (sold separately)

% Use an IP-BUS-RCA Interconnector such

as the CD-RB20/CD-RB10 (sold separetely)

to connect this unit to auxiliary equipment

featuring RCA output.

For more details, refer to the IP-BUS-RCA Inter-

connector owner’s manual.

# You can only make this type of connection if

the auxiliary equipment has RCA outputs.

Selecting AUX as the source

% Press SOURCE to select AUX (AUX1 or

AUX2) as the source.

# If the auxiliary setting is not turned on, AUX

cannot be selected. For more details, see Switch-

ing the auxiliary setting on page 51.

Setting the AUX title

The title displayed for each AUX1 or AUX2

source can be changed.

1 After you have selected AUX as the

source, press FUNCTION and hold until

TITLE IN appears in the display.

2 Enter a title in the same way as the

built-in DVD player.

For details concerning operation, refer to En-

tering disc titles on page 36.

Switching between digital and

analog

When this unit is connected to the DEQ-

P6600, you can switch to the AUX mode to

analog or digital.

1 Press SOURCE to select AUX2 as the

source.

Press SOURCE until AUX2 appears in the dis-

play.

# If the auxiliary setting is not turned on, AUX2

cannot be selected. For more details, see Switch-

ing the auxiliary setting on page 51.

2 Press BAND to switch the modes.

Press BAND repeatedly to switch between the

following modes:

ANALOG (analog) — DIGITAL (digital)

Note

When this unit is connected to the DEQ-P6600,

you can switch to the AUX mode to analog or di-

gital. However, when you use AUX2 as the

source, make sure the AUX mode is set to analog.

AUX digital should not be used with this unit.

Operating this unit

En

55

Section

03

Operating this unit

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 96 97

Commentaires sur ces manuels

Pas de commentaire