Pioneer DEX-P9R Manuel d'utilisateur Page 81
- Page / 96
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Note:
• This unit is for vehicles with a 12-volt battery and
negative grounding. Before installing it in a recre-
ational vehicle, truck, or bus, check the battery
voltage.
• To avoid shorts in the electrical system, be sure to
disconnect the ≠ battery cable before beginning
installation.
• Refer to the owner’s manual for details on con-
necting the power amp and other units, then make
connections correctly.
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake,
and seat rails. Do not route wiring in places that
get hot, such as near the heater outlet. If the insu-
lation of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to the vehicle
body.
• Don’t pass the yellow lead through a hole into the
engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
• Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
• Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
• When replacing a fuse, be sure to use only fuses
of the rating prescribed on the fuse holder.
• The black lead is ground. Please ground this lead
separately from the ground of high-current prod-
ucts such as power amps.
If you ground the products together and the
ground becomes detached, there is a risk of dam-
age to the products or fire.
• If the RCA pin jack on the unit will not be used,
do not remove the caps attached to the end of the
connector.
• When this product’s source is switched ON, a
control signal is output through the blue/white
lead. Connect to an external power amp’s system
remote control or the car’s Auto-antenna relay
control terminal (max. 300 mA 12 V DC). If the
car features a glass antenna, connect to the anten-
na booster power supply terminal.
• When an external power amp is being used with
this system, be sure not to connect the blue/white
lead to the amp’s power terminal. Likewise, do
not connect the blue/white lead to the power ter-
minal of the auto-antenna. Such connection could
cause excessive current drain and malfunction.
• To prevent incorrect connection, the input side of
the IP-BUS connector and Optical connector is
blue, and the output side is black. Connect the
connectors of the same colors correctly.
• Connection of this system requires optional opti-
cal cables (e.g. CD-AD600) and IP-BUS cables
(e.g. CD-IP600). Consult your nearest dealer for
more detail.
• Set GPS antenna away from this unit. If you set
them too close, it may fail to operate properly.
• An Optional “GEX-P900 DAB(II)” Hide-away
DAB tuner cannot be connected without connect-
ing an optional “DEQ-P9” Universal Digital
Preamp Equalizer with this unit. If you connect a
“GEX-P900 DAB(II)”, be sure to use the optional
optical cables and IP-BUS cables, and connect
between the “DEQ-P9” and this unit.
• This unit can not be installed in a vehicle that
does not have an ACC (accessory) position on
the ignition switch. (Fig. 1)
Fig. 1
• Cords for this product and those for other prod-
ucts may be different colors even if they have the
same function. When connecting this product to
another product, refer to the supplied Installation
manuals of both products and connect cords that
have the same function.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
80
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
ENG/MASTER 96
81
Connecting the Units
1/CRB1643/Eng/53~94 09-05-2001 08:29 Page 81
- Owner’s Manual 1
- Contents 2
- Key Finder 5
- When the Cover is Closed 7
- When the Cover is Open 7
- Remote Controller and Care 8
- Batteries 9
- Before Using This Product 10
- LASER PRODUCT 11
- Theft Protection 12
- Replacing the Front Panel 13
- Warning Tone 13
- ENG/MASTER 96 14
- Setting the Clock 16
- Off Clock 17
- Setting the Display 18
- Selecting the Wallpaper 19
- Selecting the Reverse Mode 19
- Switching the AUX Mode 20
- Setting the Warning Tone 20
- Setting the DAB Priority 21
- Switching the Auto PI Seek 22
- Changing the FM Tuning Step 22
- Setting the Menu Lock 23
- Basic Operation 24
- Switching Power OFF 25
- Tuner Operation 26
- Preset Tuning 29
- Using the RDS Functions 30
- PI Seek function 31
- PTY Alarm 33
- Canceling Announcements 33
- 2. Activate the TA function 35
- Regional function 37
- Storing Radio Text in Memory 39
- Recalling Preset Radio Text 39
- Built-in CD Player Operation 40
- Operating Each function 43
- Changing the Display Mode 45
- Disc Title Input 45
- Multi-CD Player Operation 46
- Random Play 49
- Scan Play 49
- Disc Title 51
- DVD Player Operation 54
- DAB Tuner Operation 59
- TRAFFIC” indicator turns to 63
- Service Component function 65
- Service Follow function 69
- TV Tuner Operation 70
- (See page 71.) 71
- Audio Adjustment 74
- Bass/Treble Adjustment 75
- Other Functions 77
- CD Player and Care 79
- Connecting the Units 81
- This Product 83
- IP-BUS output (Black) 83
- Installation 88
- Removing the Unit 89
- Fitting horizontally 90
- Fitting vertically 90
- Method A 91
- Method B 91
- Specifications 94
- PIONEER CORPORATION 96
Produits connexes et manuels pour Autoradio Pioneer DEX-P9R
(112 pages)
(116 pages)
(116 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.139 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels