Pioneer DEH-P7500MP Manuel d'utilisateur télécharger pdf (Page 46)

2 Press c or d to adjust the brightness

level.

Each press of c or d increases or decreases

the brightness level. 0  15 is displayed as the

level is increased or decreased.

Selecting the illumination

color

This unit is equipped with two illumination col-

ors, green and red. You can select the desired

illumination color.

1 Press FUNCTION to select ILLUMI.

Press FUNCTION repeatedly until ILLUMI ap-

pears in the display.

2 Press c or d to select the desired illumi-

nation color.

Pressing c or d will switch ILLUMI between

red or green and that status will be displayed

(e.g., ILLUMI :GRN)

Setting the rear output and

subwoofer controller

This units rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (REAR SP :FULL) or subwoofer

(REAR SP :S/W) connection. If you switch the

rear output setting to the REAR SP :S/W, you

can connect a rear speaker lead directly to a

subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (REAR SP :FULL). When rear

output are connected to full range speakers

(when REAR SP :FULL is selected), you can

connect the RCA subwoofer output to a sub-

woofer. In this case, you can select whether to

use the subwoofer controllers (low pass filter,

phase) built-in PREOUT:S/W or the auxiliary

PREOUT:FULL.

1 Press FUNCTION to select REAR SP.

Press FUNCTION repeatedly until REAR SP ap-

pears in the display.

2 Press a or b to switch the rear output

setting.

Pressing a or b will switch between

REAR SP :FULL (full-range speaker) and

REAR SP :S/W (subwoofer) and that status will

be displayed.

# When no subwoofer is connected to the rear

output, select REAR SP :FULL.

# When a subwoofer is connected to the rear

output, set for subwoofer REAR SP :S/W.

# When the rear output setting is

REAR SP :S/W, you cannot change the subwoofer

controller.

3 Press c or d to switch the subwoofer

output or non fading output (full-range

RCA output).

Pressing c or d will switch between

PREOUT:S/W and PREOUT:FULL and that

status will be displayed.

Notes

! Even if you change this setting, there is no

output unless you turn the non fading output

(refer to Using non fading output on page 41)

or subwoofer output (refer to Using subwoofer

output on page 41) in the audio menu on.

! If you change the subwoofer controller, sub-

woofer output and non fading output in the

audio menu return to the factory settings.

! Both rear speaker leads output and RCA rear

output are switched simultaneously in this

setting.

Initial Settings

En

46

Section

10

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 127 128

Commentaires sur ces manuels

Pas de commentaire